Loading ...
_LockNut
\Bumper
LockbarSlot_X
/
Hex Head Screw .......
DRAWER REMOVAL:
Fully extend the drawer. Push it back
a quarter of an inch.
Insert a screwdriver into the slot in the
slide and push in on the stop until it
clears the lance. Repeat the procedure
on the other slide and remove the
drawer.
Slot
j-- Stop
Lance
Lubricate _
To reinstall the drawer, pry the stop far
enough out to engage the lance (3/16"
to 1/4") and push the drawer onto the
slides until the stops pass over the
lances.
LOCK BAR:
NOTE: The locking bar is stored in
the slot in the back corner of the
plastic top.
To lock the drawers, insert the top end
of the Iockbar through the slot in the
top of the unit and over the staple on
the base.
To secure, lock with a padlock
(padlock not included).
To unlock the drawers, reverse this
procedure.
/
/
Lockbar /
PANEL:
To open: Pull the panel out, lift it up
and push it back into the unit.
To close: Reverse this procedure.
For casters, use high quality bearing
grease, (yearly).
Lubricate the slides, (twice yearly).
Periodically the drawer fronts, drawer
trim, and other surfaces should be
cleaned with a mild detergent and
water.
Auto wax will preserve the storage
unit's luster finish. Apply the wax as to
a car. The wax will also help protect the
unit against scratches.
Grease and oil can be removed with
most standard cleaning fluids. For
safety, use a nonflammable cleaning
fluid.
INTENTIONALLY LEFT BLANK
Loading ...
Loading ...