Loading ...
Loading ...
Loading ...
8
CONTROLS AND CYCLE STATUS
Sanitizes dishes and glassware in accordance with
NSF International NSF/ANSI Standard 184 for
Residential Dishwashers. Certified residential
dishwashers are not intended for licensed food
establishments. Only sanitizing cycles have been
designed to meet the requirements of the NSF/ANSI
184 performance standard for soil removal and for
sanitization efficacy. There is no intention, either
directly or indirectly, that all cycles on a NSF/ANSI
184 certified dishwasher meet the NSF/ANSI 184
performance standard for soil removal and for
sanitization efficacy.
At end of the cycle, the sanitized indicator (or word
“sanitized” on some models) will glow. If the load did
not properly sanitize, the indicator will flash at the
end of the cycle. This can happen if cycle is
interrupted or if the water does not reach the
required temperature. The light goes off when you
open and close the door or press CANCEL.
Auto
PowerBlast
®
Normal
Increases main
wash temperature
from 105°F (41°C)
to 145°F (63°C) and
final rinse from
140°F (60°C) to
156°F (69°C).
:04 to 1:15 0-3.0
(0-11.2)
Dries dishes with heat. Use option with rinse aid to
provide best drying results. Plastic items are less
likely to deform when loaded in top rack. Turn option
off for an air dry.
Auto
PowerBlast
®
Normal
Quick
Uses heating
element to speed
drying times.
:29 to :46 0
CONTROL PURPOSE COMMENTS
Press to start or resume
a wash cycle.
If the door is opened during a cycle or power is interrupted, Start/Resume indicator
flashes. Cycle will not resume until door is closed and Start/Resume is pressed.
NOTE: If Start/Resumebutton is located on top of door, push door firmly closed within
4 seconds of pressing START/RESUME. If door is not closed within 4 seconds, Start
button LED will flash, an audible tone will be heard (on some top control models), and
cycle will not start.
Press to cancel wash cycle. Close door firmly. The dishwasher starts a 3-minute drain (if needed). Let dishwasher
drain completely.
Control Lock avoids
unintended use of
dishwasher between cycles,
or cycle and option changes
during a cycle.
To turn on Lock, press and hold CONTROL LOCK or SANITIZE (depending on model)
for 3 seconds. Control Lock light will stay on for a short time, indicating that it is
activated and all buttons are disabled. If you press any button while the dishwasher is
locked, light flashes 3 times. Dishwasher door can still be opened/closed while
controls are locked.
To turn off Lock, press and hold CONTROL LOCK or SANITIZE (depending on model)
for 3 seconds. Light turns off.
NOTE: If the model requires you to press and hold Sanitize to lock controls, Control
Locked LED (C) will be on or off to indicate whether Control Lock is active or not.
OPTIONS CAN BE
SELECTED
WITH
WHAT IT DOES ADDED TIME
TO CYCLE
ADDED
WATER
GALLONS
(LITERS)
AB
C
Loading ...
Loading ...
Loading ...