Loading ...
Loading ...
Loading ...
Models with Ceramic Glass Cooktop (some models)
Operating Single Radiant Surface Elements (all Ceramic Glass Cooktop models)
Your cooktop is equipped with Single Radiant Surface Elements.
To Operate the Single Surface Elements:
1. Place correctly sized cookware on the radiant surface element.
2. Push in and turn the surface control knob in either direction to the desired setting (Figure 1).Turn
the knob toadjust the setting ifdesired. Start most cooking operations on a higher setting and then
turn to a lower setting to finish cooking. Each surface element provides a constant amount of heat
at each setting. A glowing red surface heating area extending beyond the bottom edge of the
cookware indicates the cookware is too small for the surface heating area.
3. When cooking has completed, turn the surface control knob to OFF before removing the cookware.
Note: The Surface Indicator light located under the glass cooktop will come on when the control
knob will be turn onand will continue to glow until the glass cooktop has cooled down to a moderate
level. The light may remain on even though the controls are turned OFF.
Note: See Figure 2 on page 5 for recommended control settings.
iii iiiii!iii
Figure 1
Control knob shown
is typical only.
Operating the Dual Surface Radiant Element (some Ceramic Glass Cooktop models)
Some models have 1,2, 3 or 4 Dual Radiant Surface Elements. Heat power levels Control knob shown is typical only.
are adjusted by aspecial control knob that has a dual set of graduations; for small
utensils use the small graduations (Figure 2); the inner surface only will be heating
(Figure 4). For larger utensil use the larger graduations (Figure 3); the whole
surface will be heating (Figure 5).
To Operate the Dual Surface Element:
t. Place correctly sized cookware on the dual surface element.
2. Pushinandturnthecontrolknobcounterclockwise(SeeFigure2)forsmaller
cookware or clockwise (See Figure 3) for larger cookware.
3. Turn the knob to adjust the setting ifneeded. Start most cooking operations
on a higher setting and then turn to a lower setting to finish cooking. Each
surface element provides a constant amount of heat ateach setting. A glowing
red surface heating area extending beyond the bottom edge of the cookware
indicates the cookware is too small for the surface heating area.
4. When cooking has completed, turn the surface control knob to OFF before
removing the cookware. Note: The Surface Indicator light located under the
ceramic glass will come on when the control knob will be turn on and will
continue to glow until the glass cooktop has cooled down toa moderate level.
The light may remain on even though the controls are turned OFF.
Note: See Figure 2 on page 5 for recommended control settings.
Figure2
Figure4
Figure3
Figure 5
Radiant surface elements may appear to have cooled after they have been turned off. The Hot surface indicator
light will come on and will continue to glow until the glass cooktop has cooled down to a moderate level. The glass surface
may still be hot and burns may occur if the glass surface is touched before it has cooled sufficiently.
Loading ...
Loading ...
Loading ...