Loading ...
Loading ...
Loading ...
Automatic Ice and Water Dispenser
ICE AND WATER DISPENSER FEATURES
The ice and water dispenser conveniently dispenses chilled water, ana ice
cubes or crushed ice. depending on the model. Some models have an
Acceler Ice feature that increases ice production for special occasions such
as parhes. AIsc. some models have an Acceler Freeze feature that freezes
food at a faster rate to preserve freshness
To oDerate the ice disoenser, select the ce opuon aesired using the
touehpad Press a glass against the dispensing paddle as far UP as
possible to catch all ice. To stop dispensing ice, pull glass away from
dispensing paddle. Do not remove the glass until the ice has completely
dispensed. (Complete instructions for the dispenser operation are attached
to the inside of the freezer door.)
To operate the water dispenser, press a glass against the dispensing
paddle. To stop dispensing water, pull glass away from dispensing paddle.
A drip tray located at the base of the dispenser, catches small spills and
allows them to evaporate. This drip tray is removable and dishwasher
safe. Do not pour water or excess cubes into this area because there
is no drain.
Dispenser Light (some models)
The dispenser has a light which can be turned on and off by pressing the
Light touchpad. The light also turns on automatically when ice and/or water
is dispensed. Replace light bulb with an appliance bulb of the same wattage.
Signal Arm
f
m
Filtered Ioe and Water
-
culm _ i i i Ua_Ti iiiin i iii i
FJ_n
EE WATER
How the Water Dispenser Works Ice and Water Dispenser Panel (features may vary according to model)
The water tank, located behind the drawers in the refrigerator compartment, automatically fills as water is dispensed.
For proper dispenser operation, the recommended supply water pressure should fall between 20 psi and 100 psi.
After the refrigerator is connected to the water supply, fill the water tank by drawing one glass of water. It may take
about 11/2minutes after activating the dispenser paddle before water begins to fill this first glass. Continue flushing
the system for 3 minutes to rid the tank and plumbing connections of any impurities. The water dispenser has a built in
shutoff device that will stop the water flow after 3 minutes of continuous use. Simply release the dispenser paddle to
reset the shutoff mechanism.
Chemicals from a malfunctioning softener can damage the ice maker. If the ice maker is connected
to soft water, ensure that the softener is maintained and working properly.
How the Ice Dispenser Works
The ice maker and container are located in the top of the freezer compartment. After the refrigerator is installed properly
and has cooled for several hours, the ice maker can begin making ice within 24 hours. Air in new plumbing lines may
cause the ice maker to cycle two or three times before making a full tray of ice. To begin ice production, lower the wire
signal arm to the "down" or ON position. With no usage it will take approximately 2 days to fill the ice container. The ice
maker turns off automatically when the ice container becomes full. To stop the ice maker, lift the wire signal arm until it
clicks, and locks in the "up" or OFF position.
Because of new plumbing connections, the first production of ice cubes may be discolored or have an odd flavor. These
should be discarded until the cubes made are free of discoloration and taste.
13
Loading ...
Loading ...
Loading ...