Loading ...
Loading ...
Loading ...
2_
CAUTION: Always wear safety
glasses or eye shields while assembling
snow thrower.
TOOLS REQUIRED FOR ASSEMBLY
1 - Knife to cut carton
The figure to the right shows the snow
thrower completely assembled.
References to the right or left hand side
of the snow thrower are from the viewpoint
of the operator's position behind the unit.
TO REMOVE SNOW THROWER
FROM CARTON
• Locate and remove container of Crafts-
man 2-cycle oil.
• Remove the inserts positioned around the
unit and the packing matedal.
• Cut down two comers nearest the
handles and lay the panel down flat.
• Remove and discard bottom packaging.
• Pull snow thrower out of the carton.
TO ASSEMBLE THE SNOW
THROWER
• Remove wrap on upper handle and along
the side of both handles. Discard wrap.
• Loosen the tee knobs on each side of the
upper handle. See figure on this page.
• Raise the upper handle to the operating
position as shown in figure.
• NOTE: Make sure the cables are not
caught between the upper and lower
handle.
• Check to be sure the clutch cable is not
caught in the handle. Tighten the tee
knobs.
AugerControl
Chute Control
Tee Knob
Chute Deflector
J CHECKLIST
Beforeyou operateyour new snow thrower,
toensure that you receivethe best perfor-
mance and satisfactionfromthisquality
product,please reviewthe following
checklist:
,/ All assembly instructions have been
completed.
,/ The discharge chute rotates freely.
/ No remaining loose parts in carton.
While learning how to use your snow
thrower, pay extra attention to the following
important items:
// Make sure gas tank is filled with
40:1ratio mixture of gasoline and oil.
,/,/ Become familiar with all controis-thalr
location and function. Operate controls
before starting engine.
Loading ...
Loading ...
Loading ...