Loading ...
Loading ...
Loading ...
WerecommendCraftsmanbrand
syntheticoil.Mixgasolineandoilata
ratioof40:1.A40:1ratioisobtained
bymixing3.2ouncesofoilwith1
gallonofunleadedgasoline.Included
withthistrimmerisa3.2ounce
containerofoil.Pourtheentire
contentsofthiscontainerinto1gallon
ofgasolinetoachievetheproperfuel
mixture.DONOTUSEautomotiveoilor
boatoil.Theseoilswillcauseengine
damage.Whenmixingfuel,follow
instructionsprintedoncontainer.
Onceoilisaddedtogasoline,shake
containermomentarilytoassurethat
thefuelisthoroughlymixed.Always
readandfollowthesafetyrules
relatingtofuelbeforefuelingyourunit.
IMPORTANT
Experienceindicatesthatalcohol
blendedfuels(calledgasoholorusing
ethanolormethanol)canattractmois-
turewhichleadstoseparationand
formationofacidsduringstorage.Acidic
gascandamagethefuelsystemofan
enginewhileinstorage.Toavoiden-
gineproblems,emptythefuelsystem
beforestoragefor30daysorlonger.
Drainthegastank,starttheengineand
letitrununtilthefuellinesandcarbure-
torareempty.Usefreshfuelnextsea-
son.Neveruseengineorcarburetor
cleanerproductsinthefueltankorper-
manentdamagemayoccur.
SeetheSTORAGEsectionforadditional
information.
HOW TO STOP YOUR UNIT
• To stop the engine, move the ON/
OFF switch to the OFF position.
HOW TO START YOUR UNIT
_WARNING: The trimmer head
will turn while starting the engine.
Avoid any contact with the muffler. A
hot muffler can cause serious burns.
STARTING A COLD ENGINE
NOTE: DO NOT squeeze the throttle
trigger until the engine has started and
runs.
1= Set unit on a flat surface.
2= Move ON/OFF switch to the ON
position.
3. Slowly press the primer bulb 6
times.
4. Move the start lever to the START
position.
Handle
Primer Bulb Muffler
5. Pull starter rope handle sharply
until engine starts and runs.
6. Allow unit to run for 10-15 seconds,
then fully squeeze the throttle trigger
to disengage the starting system.
STARTING A WARM ENGINE
1. Move ON/OFF switch to the ON
position.
2. Move the start lever to the RUN
position.
3. Squeeze and hold the throttle trig-
ger. Keep throttle trigger fully
squeezed until engine runs
smoothly.
4. Pull starter rope sharply while
squeezing throttle trigger until en-
gine runs.
NOTE: Normally, the warm starting
procedure can be used within 5-10
minutes after the unit is turned OFR If
the unit sits for more than 10 minutes
without being ran, it will be necessary
to start the unit by following the steps
under STARTING A COLD ENGINE or
following the starting instruction steps
shown on the unit.
STARTING A FLOODED ENGINE
Flooded engines can be started by
placing the ON/OFF switch in the ON
position. Move the start lever to the
RUN position and fully squeeze throttle
trigger. Pull the starter handle repeat-
edly while squeezing throttle trigger
until engine starts and runs. This
6
Loading ...
Loading ...
Loading ...