Loading ...
Loading ...
Loading ...
5
WARNING
• When you dispose of your old refrigerators and
freezers, remove any doors. Children can suffocate
if they get trapped inside.
• This appliance contains insulation formed with
flammable blowing gases. Avoid safety hazards by
carefully disposing of this appliance.
• The appliance must be plugged into its own
dedicated 220-240V, 50Hz AC electrical outlet.
• Ensure that the electric outlet is properly earthed
to ground. Consult a qualified electrician if you are
unsure.
• Do not use an extension cord or adaptor plug.
• Unplug the appliance before cleaning.
• Never unplug the appliance by pulling on the power
cord. Always grip the plug firmly, and pull straight
out of the receptacle to prevent damaging the
power cord.
• Chose a location that is not too cold - the
temperature should be above 10°C.
• Chose a location that is not affected by direct
sunlight.
Protection from Moisture
Avoiding placing the refrigerator in a place where heavy
moisture is present so as to minimise possibility of rusting
of metal parts. The refrigerator should be kept out of
water or direct sprayed water, failure to do this could
cause poor performance and/or an electrical short could
occur.
Protection from Heat
The refrigerator should be protected from excessive heat
sources and out of direct sunlight.
Moving
When fixed or moved, the refrigerator cannot be set
horizontally or reclined to more than 45° or positioned
upside down.
Never move while refrigerator is plugged in and
operating.
Once you have moved the refrigerator, leave standing in a
level position for 4 - 6 hours so that the gas can settle.
• Put the appliance in a dry place, avoiding areas of
high moisture or humidity.
• Don’t put the appliance in direct sunlight.
• Don’t put the appliance near stoves, fires or heaters.
• The appliance shall not be exposed to rain.
• Keep ventilation openings, in the appliance
enclosure or in the built-in structure, clear of
obstruction. Do not use mechanical devices or
other means to accelerate the defrosting process.
• Do not use electrical appliance inside the food
storage compartments of the appliance.
• If power cord is damaged, it must be replaced by
the manufacturer or its service agent or a similarly
qualified person in order to avoid a hazard. The
appliance is not to be used if the power cord is
damaged.
• The electrical system of this refrigerator must be
connected with an automatic 30mA circuit breaker
and/or residual current device (RCD). If uncertain
have a qualified electrician check your electrical
system before installation and/or use.
Positioning
Ensure the sides and top have at least 50mm clearance
and the rear at least 100mm clearance to ensure
adequate ventilation.
Never cover the bottom front grill as this is required for
ventilation.
After installation the appliance should be left for
4 - 6 hours before it is switched on in order to allow the
refrigerant to settle.
Disposal of Old Appliances
The majority of components are recyclable, however there
are also dangerous chemicals inside. To dispose of old
fridges remove the doors and contact your local council
for recycling options.
Electrical Installation
The electrical system of this refrigerator must be supplied
through a residual current device (RCD) having a rated
residual operating current not exceeding 30 mA. If
uncertain have a qualified electrician check your electrical
system before installation and/or use.
Loading ...
Loading ...
Loading ...