Loading ...
'_v__ _ _ g_ _ __'_1__
ACCUDRY TM System
Automatic cycles may be used to dry most loads. Your dryer uses
the electronic ACCUDRY TM system. The control senses the
moisture level in the load and shuts off when the load reaches the
selected dryness.
The cycle control knob does not move until the load is almost dry.
After the Cool Down, the knob automatically turns to an Off area
and tumbling stops.
Most loads may be dried using the Energy Preferred setting. At
the end of the cycle, check the dryness of the load.
• Ifthe load is drier than you like, you may select a setting closer
to Less Dry the next time you dry a similar load.
• If a load is not as dry as you like, you may complete drying
using a Timed cycle. You may select a setting closer to Very
Dry the next time you dry a similar load.
NOTE: Drying time with an automatic cycle varies according to
the type of fabric, size of load, and temperature setting.
WRINKLE SHIELD" Plus Setting
When you are unable to remove a load from the dryer as soon as it
stops, wrinkles can form. The WRINKLE SHIELD TM Plus feature
periodically tumbles, rearranges and fluffs the load without heat to
avoid wrinkles.
The WRINKLE SHIELD TM Plus selector lets you choose 30 or 90
minutes of periodic unheated tumbling after the cycle ends.
A signal will sound periodically when the WRINKLE SHIELD TM
Plus feature is on, if the End of Cycle Signal is selected. The signal
and the tumbling will end when you open the dryer door or turn
the Cycle Control knob to "Off."
TIMED DRYING
These cycles may be used to complete drying if items are still
damp after the automatic cycle ends.
Timed Drying is also useful for:
• Heavyweight or bulky items that require a longer drying time.
• Lightweight items that require a short drying time.
NOTE: On some models, temperature is included in the cycle
selections. On models with a selectable temperature knob, you
may choose a setting based on the fabrics in your load. Drying
time and temperature will depend on your dryer model.
DRYEL* fabric care system
When using DRYEL* fabric care, you may select the DRYEL* cycle
setting and the DRYEL* temperature setting. DRYEL* fabric care,
when used in accordance with the manufacturer's directions, has
been tested and approved for use in full-size dryers built by
Whirlpool Corporation.
You may select a drying temperature based on the fabrics in your
load. If you are unsure of the temperature to select for a load,
select the lower setting rather than the higher setting.
Temperature Tips
If your dryer has multiple heat settings:
• A high heat setting may be used for drying heavyweight items
such as towels and work clothes.
• A low to medium heat setting may be used for drying medium-
weight items such as sheets, blouses, dresses, underwear,
permanent press fabrics, and some knits.
• An extra low heat setting may be used for drying lightweight
items such as lingerie.
• You may use a no heat (air) setting for rubber, plastic or heat-
sensitive fabrics.
• Line dry bonded or laminated fabrics.
NOTE: If you have questions about drying temperatures for
various loads, refer to the care label directions.
The End of Cycle signal sounds when a cycle is complete. The
End of Cycle signal is selectable and the signal will sound only if
set to On.
If the WRINKLE SHIELD TM feature is selected and the End of
Cycle Signal is on, the signal sounds every few minutes. The
signal stops when you open the door or turn the Cycle Control
knob to Off.
The drying rack is useful for machine drying items you would not
necessarily want to tumble dry or that you would normally line dry
(for example, pillows and stuffed toys).
For ordering information, please refer to the service numbers
located on the front page of the dryer user instructions or contact
the dealer from whom you purchased your dryer.
Loading ...
Loading ...