Loading ...
Loading ...
Loading ...
8
Elliptical T
rainer
XE295
1. Mate the Connecting Arm Covers (R) (58) with the Connecting Arm Covers (L) (58-1) on left and right
Connecting Arms (8 & 9). Make sure these covers are oriented the correct way. There is an arrow ^ mark on
the inside. Fasten together with four Phillips Head Screws (105) and four Sheet Metal Screws (87). Tighten with
the Short Phillips Head Screw Driver (107). Then mate the Connecting Arm Covers (R) (57) with (L) (57-1)
on Swing Arm (L) (10) and Swing Arm (R) (11), respectively. Fasten together with four Phillips Head Screws
(105) and four Sheet Metal Screws (87). Tighten with the Short Phillips Head Screw Driver (107).
2. Fasten the two Wheel Covers (52) to the roller sets with four Phillips Head Screws (105). Tighten with the
Phillips Head Screw Driver(108).
3. Attach the left side cover (19) and right side cover (20) to the mid-stabilizer tube with two Phillips Head
Screws (105). Attach the right side cover (20) and left side cover (19) to the rear stabilizer tube with two
Phillips Head Screws (105). Tighten all four screws with the Phillips Head Screw Driver (108). Then attach the
Front Stabilizer Cover (49) with two Phillips Head Screws (105). Tighten with the Phillips Head Screw Driver
(108).
4. Install the Front Handle Bar Covers (L & R) (54 & 55) and Rear Handle Bar Covers (L & R) (54-1 & 55-1)
over the Handle Bars axle connections with four Sheet Metal Screws (87) on each side. Tighten with the Phillips
Head Screw Driver (108).
5. Look closely at the four oor levelers underneath the middle and rear of the elliptical. If any of these aren’t
in contact with the oor, use the wrench (124) to loosen the bottom nut. Once the nut has been loosened,
turn the rubber pad clockwise until it makes solid contact with the oor. Retighten the bottom nut to prevent it
from moving.
HARDWARE
STEP 4: Plastic Parts
#87. 3.5 x 12mm
Sheet Metal Screw
(16 pcs)
#105. M5 x15mm
Phillips Head Screw
(18 pcs)
Loading ...
Loading ...
Loading ...