Loading ...
Loading ...
Loading ...
D ¸_ _ _ _ _ D_ _
Excessive Weight Hazard
Use two or more people to move and install ice maker.
Failure to do so can result in back or other injury.
PROBLEM RECOMMENDED SOLUTIONS
Water Not Entering Drain
Properly
Is the drain hose aligned over the drain? Move the ice maker to align the drain. See "Connect
Water Supply."
NOTE: Service technicians cannot repair plumbing problems outside of the ice maker. Call a
licensed, qualified plumber.
To order accessories, call 1-800-4-MY-HOME ® and ask for the
appropriate part number listed below or contact your
authorized Kenmore dealer.
Water Filter
Order Part Number 9934
Cleaner
Order Part Number 4396808
Stainless Steel Cleaner
Order Part Number D22 M40083 R
PERFORMANCE DATA SHEET
Ice Maker Water Filtration System
Model P6GEG2KL, P6KG2KL, P6WG2KL Capacity 2000 Gallons (7571 Liters)
System tested and certified by NSF
International against NSF/ANSI
Standard 42 for the reduction of
Chlorine Taste and Odor.
This system has been tested according to NSF/ANSI Standards 42 for the reduction of the substances listed below. The
concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal
to the permissible limit for water leaving the system, as specified in NSF/ANSI Standards 42.
Substance Reduction NSF Reduction Average Influent Challenge Maximum Average Minimum °/o Average °/o
Aesthetic Effects Requirements Influent Concentration Effluent Effluent Reduction Reduction
Chlorine Taste/Odor 150%reduction 11.9727mg/L12.0mg/L -t- 10O/o 10.71mg/L 10.7788mg/L 170.2 172.81
Test Parameters: pH = 7.5 -t- 0.5 unless otherwise noted. Flow = 0.50 gpm (1.89 Lpm). Pressure = 60 psig (413.7 kPa).
Temp. = 68°F to 71.6°F (20°C to 22°C). Rated service capacity = 2000 gallons (7571 liters).
• It is essential that operational, maintenance, and filter
replacement requirements be carried out for the product to
perform as advertised.
• Use replacement filter P6RFWG2K, P6RFGEG2K,
P6RFKG2K, Part Number ICE2.
Style 1- When the water filter status display changes from
"GOOD" to "ORDER," order a new filter. When the filter
indicator reads "REPLACE," it is recommended that you
replace the filter.
Style 2 - Press FILTER to check the status of your water filter.
If the filter indicator light is yellow and the words "ORDER
FILTER appear on the display screen, order a new filter. If
the filter indicator light is red, it is recommended that you
replace the filter.
• These contaminants are not necessarily in your water supply.
While testing was performed under standard laboratory
conditions, actual performance may vary.
• The product is for cold water use only.
• Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or
after the system.
• Refer to the "Warranty" section for the Manufacturer's
name, address and telephone number.
• Refer to the "Warranty" section for the Manufacturer's
limited warranty.
Application Guidelines/Water Supply Parameters
Water Supply City or Well
Water Pressure 30 - 120 psi (207 - 827 kPa)
Water Temperature 33 °- IO0°F (0.6 ° - 37.8°C)
Service Flow Rate 0.50 gpm (1.89 Lpm) @ 60 psi
® NSF is a registered trademark of NSF International.
21
Loading ...
Loading ...
Loading ...