Loading ...
Loading ...
Loading ...
22
REFERENCE
TROUBLESHOOTING
Symptom
Possible solution
• Verify that the fan’s circuit breaker has power and that it is on.
• Check for secured plug connections. Each connection should be checked to
ensure they are fully engaged.
• Inspect for loose wiring connections. Each termination should be checked
to be sure they are rmly tightened.
1. Power Cycle the Fan
2. Long hold on both button
and DOWN. You will see LED is on.
3. Wait until the LED is off
4. While still pressing button
, release button DOWN.
5. Keep pressing button
and have a short press on the button DOWN.
6. You will see LED blinks 5 times for command sent conrmation. Release
button
.
1. Long hold on both button OFF and DOWN. You will see LED is on.
2. Wait until the LED is off
3. While still pressing Power button, release button DOWN.
4. Keep pressing button OFF and have a short press on the button DOWN.
5. You will see LED blink once for command sent conrmation. Release the
power button.
FAN WILL NOT START
MOTOR IS PULLING
EXESSIVELY HIGH AMPS
• Make sure the motor voltage is a match for the supply voltage.
FAN IS “SWINGING” AS IT
RUNS
• Check for correct fan blade installation. Be sure that all blades have been
properly installed according to color and are tightened.
• Ensure all downrod hardware has been tightened.
• Check for improper incoming air discharge. Make sure that no discharge is
blowing directly on the fan.
A FAN BLADE APPEARS TO
BE ‘SAGGING’
TO UNPAIR A REMOTE
FROM A FAN(S):
TO PAIR A REMOTE TO
A FAN(S):
TO TOGGLE DIMMING MODE:
• Make sure that the ‘sagging’ blade has been properly tightened.
• Turn OFF Power to Fan for at least 5sec, and then restore Power. Hold down
both the “Fan OFF” and “
” button at the same time. The remote LED will
ash after several seconds. Fan will emit audible “BEEP” to conrm the
operation.
For situations beyond the scope of this Guide,
please call our Technical Service Department at
1-844-593-3267 (FANS).
180 Threet Industrial Road
Suite 120, Smyrna, TN 37167
HUNTERFAN.COM
©2020 Hunter Fan Company. All rights reserved.
MI001-01 020620