Loading ...
WARNINGS
Do not touch any hot surfaces
Do not immerse unit, cord or plug in liquid at any time
Unplug cord from outlet when not in use and before cleaning
Plug only into a 3-hole grounded electrical outlet
Do not operate unattended
Do not use this unit for anything other than intended use
Do not use outdoors
Always use on a firm, dry and level surface at least 12” from walls or any other obstruction
Do not use if unit has a damaged cord or plug, in the event the appliance malfunctions, or has been damaged in
any manner
Keep children and animals away from unit
Any incorrect installation, alterations, adjustments and/or improper maintenance can lead to property loss and
injury. All repairs should be done by authorized professionals only
Ensure that the designated power supply is adequate for continual usage and the voltage is correct
Scalding may occur if the lid is removed during the brewing cycle.
TO USE
1. Clean the filter basket, cover, percolator tube and the inside of the tank with a non- abrasive
detergent.
2. Pour cool water into the urn to fill at least half of the total capacity of the urn.
3. Cover the filter basket with the basket cover.
4. Center the percolator tube into the basket and tray. Make sure that the base of the tube is positioned
securely in the well of the urn.
5. Center the filter basket into the percolator tube and place ground coffee in the basket. Put the
basket cover back on and put the cover on the urn.
6. Plug the cord into your electrical outlet and turn the power switch on. The switch will light up.
7. When the indicator lamp lights up the brewing process is complete.
8. The second heating system will start to operate automatically to keep the coffee warm.
9. When there are only about 3 cups of coffee left in the urn, turn the power switch off and unplug the
cord from the outlet.
10. To reheat cold coffee in the urn, there must be at least 12 cups of coffee in the tank to reheat. Simply
re-plug the cord back into the electrical outlet and turn the power switch on.
SEDIMENT REMOVAL
*On areas of the heating element, hard water will cause chalk and limestone to accumulate over time. It is
recommended that you clean the percolator and remove the residue.
1. Pour 100 ml. of fresh lemon juice into the urn body
2. Wait 5-6 minutes to allow the lemon juice to run through the sediments
3. You can use a soft bristle brush to clean the heating element
4. Repeat steps 1-3 until limestone is removed
5. Use a dry cloth to wipe the residual liquid
6. Pour clean water into the urn until and rinse until lemon smell is gone
Loading ...
Loading ...
Loading ...