Loading ...
Loading ...
Loading ...
Symptom Cause / Solution Page
Dolby PLg mode or DTS
Neo:6 mode cannot be
selected.
0
It cannot be selected when “Speaker Config.” - “Center” or “Surround” is set for “None”.
179
0
Dolby PLg or DTS Neo:6 cannot be selected when using headphones.
－
Audyssey MultEQ
®
,
Audyssey Dynamic EQ
®
and Audyssey Dynamic
Volume
®
cannot be
selected.
0
These cannot be selected when you have not performed Audyssey
®
Setup.
168
0
Switch to a sound mode other than “Direct” or “Pure Direct”.
114
0
These cannot be selected when using the headphones. －
“Restorer” cannot be
selected.
0
Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of
multichannel signals such as Dolby Digital or DTS surround, “Restorer” cannot be used.
146
0
Switch to a sound mode other than “Direct” or “Pure Direct”.
114
No sound is output when
using ZONE2.
0
Digital signal audio input from the HDMI connector or digital audio connectors (OPTICAL/COAXIAL)
cannot be played back. Use analog connections.
－
0
When listening to the audio of a Bluetooth device in ZONE2, remove any obstructions between the
Bluetooth device and this unit and use it within a range of about 32.8 ft/10 m.
－
Contents Connections Playback Settings Tips Appendix
210
Front panel Display Rear panel Remote Index
Loading ...
Loading ...
Loading ...