Loading ...
Loading ...
Loading ...
nstallati
Mode/18
ff youhave questions,call 1.800.GE.CARESor vMt our Webske at: GEAppliances.com
in Canada, call 1.800.561.3344or visit oui-Website,t: www.GEAppliances.ca
BEFORE YOU BEGIN
Read these instructions completely and carefully.
" IMPORTANT - S.vethese
instructions if)r local inspector's use.
" IMPORTANT - Obseiveall
governing codes and ordinances.
* Note to Installer - Be sure to leave these
instructions with tile Consumei:
, Note to Consumer - Keep these instructions
K)r future reference.
* Skill level - Installation of this appliance requires
basic mecllanical skills.
* Completion time - Refligerator Installation
15 minutes
Reversing the Door Swing
1 llour
* Proper installation is tile responsibility of tile
installer.
* Product failure due to improper installation is not
covered under the _!arIallty.
WATER SUPPLY TO THE ICEMAKER
{on some models}
If tlle refrigerator has an icemaker, it will llave to be
connected to a cold water line. A water supply kit
(containing copper robing, shutoff valve, fittings and
instructions) is available at extra cost f]om your dealei;
by visiting our Website at GEAppliances.com (in
Canada at www.GEAppliances.ca) or flom Parts and
Accessories, 1.800.661.1616.
CLEARANCES
Allow file following clearances for ease of installation,
proper air circulation and phmlbing and electrical
connections.
- Sides 1/8" (3 ram)
- Top 1" (25 ram)
- Back 1" (25 ram)
If the refligerator is to be installed next to a wall on the
llinge side, allow 5/16" (8 ram) door clearance.
ROLLERS AND LEVELING LEGS
Rollers allow you to move file refligerator away flom the
wall for cleaning.
Leveling Legs near each flont corner of tile refligerat(m
next to the rollers, should be adjusted if any of the
following occurs:
- Refligerator wobbles due to flont roller not being firmly
positioned on tile floor
" Door(s) do not close easily when opened to 45 °.
NOTE:
" BEFORE moving file refligerator away flom the wall,
be sure to turn tile leveling legs cotmterclockwise so that
the weight of the refligerator is fiflly transferred to the
flont rollers.
" Tile refligerator will not be level flom flont to back. It
will have a slight backward flit for proper doo>closing.
To adjust the leveling legs, 1 <:------__
tHI'II tile two flont leveling ..... -......
legs clockwise to raise the
fiont of tile reflfgerator and
counterclockwise to lower it.
ise to raise
refrigerator
REFRIGERATOR LOCATION
=Do not install tile refligerator where the tenlperamre
will go below 60°F (16°C) because it will not run often
enougtl to maintain proper temperatures.
" Do not install the refligerator wllere tlle temperature
will go above 100°F (37°C) because it will not perform
properly.
" Install it on a floor strong enough to support it flflly
loaded.
10
Loading ...
Loading ...
Loading ...