Loading ...
Loading ...
Loading ...
r TROUBLESHOOTING cont.
If you experience Possible Causes Somufion
Cycle time too short Automatic cycle ending early. The load may not be contacting the sensor strips. Level the dryer.
Use Timed Dry for very small loads. Change the dry level
setting on Auto Moisture SensingTM/Auto Dry cycles.
increasing or decreasing the dry level setting wJJJchange the
amount of drying time in a cycle.
Lint screen clogged.
Dryer fabric softener not properly
used.
Lint on load Lint screen should be cleaned before each load.
Stains on load or drum
Add dryer fabric softener sheets at the beginning of the cycle.
Fabric softener sheets added to a partially dried load can stain
your garments.
Drum stains are caused by dyes in clothing (usually blue jeans).
These wJJJ not transfer to other clothing.
Loads are wrinkled The load was not removed from dryer Select Wrinkle Guard TM option to tumble the load without heat
at the end of the cycle, to avoid wrinkling.
Dryer tightly packed. Dry smaller loads that can tumble freely reduce wrinkles from
forming.
Odors You have recently been painting, If so, ventilate the area. When the odors or fumes are gone from
staining, or varnishing in the area the area, rewash and dry the clothing.
where your dryer is located.
The electric dryer is being used for The new electric heating element may have an odor. The odor
the first time. wJJJbe gone after the first cycle.
Load is too hot Laundry items werer removed from Allow Cool Down to finish before removing laundry from dryer.
the dryer before the end of the All cycles are cooled slowly to reduced wrinkling and make it
cycle, easier to handle. Items removed before Cool Down may feel
very warm.
A high temperature cycle was used Select a lower temperature, and use an automatic drying cycle.
or the Dry Temp was set on high. These cycles sense the temperature or the moisture ievei in the
load and shut of]: when the load reaches the seiected dryness.
k_,. This reduces overdryJng. ._
12
Loading ...
Loading ...
Loading ...