Loading ...
Loading ...
Loading ...
ActionPossible causesProblem
No action. The programme time is stored and
next time the programme is run the corrected
time will be displayed.
The program is taking longer than estimated.1 minute appears in the display.
Clean the coarse and fine filters.The filters are blocked.Water remains in the dishwasher.
Check that the filter handle is locked in the stop
position. The handle should point towards the
back of the dishwasher.
The filters are not fitted correctly.
Clean the drainage pump. See the chapter Care
and cleaning.
Debris in the drainage pump.
Check that the coloured stop on the right in the
bottom drain is in place. See the chapter Care
and cleaning.
Drainage pump stop missing.
Check that the hose is free from kinks and sharp
bends.
Kink in drainage hose.
Disconnect the drainage hose where it connects
to the sink unit's water trap. Check that no debris
has fastened and that the connection has an in-
ner diameter of at least 14 mm.
Blocked drainage hose.
Clean with washing-up brush and low foaming
cleaner.
Dirt around the seals and in corners.Bad odour in dishwasher.
Run a program with a higher temperature once
or twice a month. Or run a self-cleaning program.
See Self-cleaning in Chapter Using the dishwash-
er.
Low temperature programs have been selected
for a prolonged period.
Fully load the dishwasher.The dishwasher is not fully loaded.The dishes are not dry enough.
Top up with rinse aid or increase the rinse aid
dosage level. See the chapter Settings.
Rinse aid needs topping up or dosage is set too
low.
Change your all-in-one detergent or deactivate
the setting TAB and top up with salt and separate
rinse aid. See Rinse aid in the chapter Settings.
The setting TAB is activated and all-in-one deter-
gent with insufficient drying effect is being used.
Open the door a little once the program has fin-
ished.
18
Loading ...
Loading ...
Loading ...