Loading ...
Loading ...
Loading ...
Page 6
III / Operational Safeguards
Do not operate or install your KwiKool unit in a potentially explosive, combustible, or
corrosive gas atmosphere.
Keep your KwiKool system away from flammable materials and open flame.
To avoid electrical shock keep your KwiKool system away from direct contacts with
water and any liquids and do not touch your system with wet hands.
To insure your KwiKool system is stable, the floor on which the system is to be place
should be level, free of vibration and strong enough to support the weight of your
KwiKool model.
Do not move the system while it is operating. Before moving the system, first turn
system to OFF then unplug the system from the power source. Then unlock casters.
Do not tilt or overturn your unit, since this could damage the compressor.
Do not place objects on top of your unit.
Do not insert your hand or any other object into the cold air supply chutes.
Do not operate your KwiKool system with its service doors open.
If your KwiKool system makes abnormal noises or vibrations, call KwiKool at
1-800-594-5665.
B.
A.
C.
D.
F.
E.
G.
H.
I.
J.
Power Connection - Verify that the source power, phase and breaker size is
compatible with your KwiKool serial plate information and that the electrical circuit is
dedicated only for the use of your KwiKool Unit. If you aren’t sure about your power,
contact a licensed electrician. KwiKool systems are factory equipped with 8 feet of
power cable sized to meet the power requirement of your system. Extension power
cable is allowed but cannot exceed 25’ and must be rated to operate your KwiKool.
KwiKool units that come supplied with a factory installed plug require the exact recep-
tacle to match the plug and exact circuit size and power. Cutting the power plug on your
KwiKool unit will void its warranty. All other KwiKool systems over 3-tons are not
equipped with a male plug and must be hard wired by a qualified personal.
**Note: 208/230 volt systems require voltage to be selected to the proper voltage
before operating your unit. This is controlled by a rocker switch located on the top of the
control box in the service door. The factory default selection is 208 volts for KwiKool
systems purchased after June 2016 and 230 volts for equipment purchased before this
date. Always set teh voltage incoming to the correct setting to avoid potential opera-
tional issues. Read the Operational Safeguard section before applying electrical power.
D.
Read the following safeguards carefully before installing your KwiKool:
Loading ...
Loading ...
Loading ...