Loading ...
Loading ...
Loading ...
7
6. INSTALLATION INSTRUCTIONS
6.1 FOR PARALLEL ARM (PUSH SIDE)
MOUNTING
This installation process covers parallel arm
installations up to 180º openings.
1. Select the door opening angle and use the
dimensions shown opposite. Mark four holes on
the door for the door closer and four holes on
the underside of the frame for the parallel
bracket.
2. Drill 4mmØ pilot holes in the door and frame
for the fixings supplied.
3. Attach the closer to door using screws provided,
speed adjusting valve must be positioned away
from hinge edge.
4. Fix parallel arm bracket to the frame using
screws provided.
5. Using a wrench on the square shaft at the
bottom of the closer, rotate the shaft 100mm to
125mm towards the hinged edge of door. Hold
and place the main arm of the shaft on top of
the closer at the index mark, as on “top view”
illustration.
For left hand door illustration A.
For right hand door illustration B.
Tighten arm screw with lockwasher securely.
6. Remove arm shoe from forearm and discard.
Install rod end of forearm to bracket using the
screw/washer assembly provided.
7. Adjust forearm length so that adjustable
forearm is parallel to the frame.
8. Adjust the closing speed of the door using the
procedure detailed on page 8.
STOCK No. 62890
PART No.DC45/85
OPENING TO 120º
DIMENSION A = 200mm
DIMENSION B = 150mm
OPENING FROM 120º TO 180º
DIMENSION A = 170mm
DIMENSION B = 120mm
TYPICAL
TOP VIEW
INSTALLATION
PARALLEL ARM INSTALLATION
Closer installs on PUSH/STOP side of door
Illustrated
Left Hand Door - LH or
Right Hand Reverse - RHR
Loading ...
Loading ...
Loading ...