Loading ...
Loading ...
Loading ...
6
1886
Ceiling Bracket Hanging Fan Wiring Motor Housing Blades Light Control
Installing the Glass
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
NOTE: Check to ensure
proper engagement.
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
Notch
Tab
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Assembling the Light Kit
Align the keyhole slots in the top of the light kit
assembly with the partially installed assembly
screws. Rotate the keyhole slots around the
screws and twist counterclockwise. Tighten all
three screws securely.
Partially install two light kit
assembly screws, found in the
hardware bag, halfway into
the motor housing as shown.
It does not matter which two
screw holes you choose.
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light xture.
2 of 7
Light Kit Screw
BAG
1 of 7
Light Kit Screw
BAG
2 of 7
Light Kit Screw
BAG
2 of 7
Light Kit Screw
BAG
Raise the LED assembly to the trim ring. Align the
screw holes in the LED assembly with the screw
holes in the trim ring. Screw two light kit assembly
screws, found in the hardware bag, through the
LED assembly and into the trim ring.
Connect the single-pin connectors from
the LED assembly to the connectors
from the fan. Connect the white wires
together. Connect the blue and black
wires together. Tuck the excess wiring
above the LED assembly or feed back
into the lower switch housing.
Raise cap to the LED assembly. Align the
notches on the sides of the cap with the screw
holes in the LED assembly. Install the two LED
assembly screws which can be found in the
hardware bag.
ON
Turn Power
Loading ...
Loading ...