Loading ...
Loading ...
Loading ...
22 23
22 23
3. Square the saw on the mounting
surface and mark the location of the
four 3/8 in. mounting holes (1).
4. Drill a 3/8 in. hole into the mounting
surface.
5. Mark an 11 in. square (2) centered
between the four mounting holes (1).
6. Cut out and remove the square.
7. This opening will allow sawdust to
fall through the saw base.
8. Place the saw on the work surface,
and align the mounting holes of the
saw with those drilled through
the surface.
9. Fasten the saw to the work surface.
Do not operate this machine on the
floor. This is very dangerous and
may cause serious injury.
INSTALLING THE DUST BAG (FIG. J)
● Do not use this saw to cut and/or
sand metals. The hot chips or
sparks may ignite sawdust or the
bag material.
● To prevent hazard, clean and
remove sawdust from under the
saw frequently.
Fig. I
WARNING
!
2
1
SQUARE
CUTOUT
1. The hooks (2) located inside of the
four legs are used to hold the dust
bag (1).
2. Attach the dust bag (1) to the four
hooks located inside of four legs.
INSTALLING THE PUSH-STICK
STORAGE HOLDER (FIG. K)
Attach the metal push-stick storage
bracket (1) into the provided slots on
the left side of the body shell.
The
bracket will snap into place.
WARNING
!
Fig. J
1
3
2
Fig. K
2
1
1
Loading ...
Loading ...
Loading ...