Loading ...
Loading ...
Loading ...
Problem
Engineis running,butno A€ outputis
available.
Engine runs goodat no-load hut "hogs
down" when loads are connected.
Engine will not start; orstarts and runs
Csuse
1. One of the circuit breakers is open.
2. Faultin generator.
3. Poor connection or defective cord
set.
4. Connected device is bad.
1. Short circuit in a connected load.
2. Enginespeed is too slow.
3. Generator is overloaded.
4. Shorted generator circuit.
1. Rocker Switch set to "Off".
2. FuelValve is in "Off" position.
3. Dirty air cleaner.
4. Out of fuel.
5. Stale fuel.
6. Spark plug wire not connected to
Cerreciien
1. Reset circuit breaker.
2. Contact Searsor other qualified
service dealer.
3. Checkand repair.
4. Connectanother device that is in
good condition.
1. Disconnect shorted electrical load.
2. Contact Searsor other qualified
service dealer.
3. SeeDon't OverloadGenerator.
4. Contact Searsor other qualified
service dealer.
1. Set switch to "On".
2. Turn fuel valveto "Open"position.
3. Cleanor replace air cleaner.
4. Fill fuel tank.
5. Drain fuel tank and carburetor; fill
with fresh fuel.
6. Connectwire to spark plug.
rough.
spark plug.
7. Badspark plug.
8. Water in fuel.
9. Flooded.
7. Replacespark plug.
8. Drain fuel tank and carburetor; fill
with fresh fuel.
9. Wait 5 minutes and re-crank engine.
Engine shutsdown when running.
Engine lacks power.
Engine"hunts" (speed constantly
fluctuates) or falters.
10. Excessivelyrich fuel mixture.
Out of fuel.
1. Loadis too high.
2. Dirty air filter.
Carburetor is running too rich or too
lean.
10. Contact Searsor other qualified
service dealer.
Fill fuel tank.
1. SeeDon't OverloadGenerator.
2. Replaceair filter.
ContactSears or other qualified service
dealer.
21
Loading ...
Loading ...
Loading ...