Loading ...
Loading ...
Loading ...
4
The following tools are required to assemble and install the casters to the unit:
Tools Needed
First Steps
Uncrating and Set-up
1. Remove carton and all loose parts from
inside the unit.
2. Remove the rear access guard and place
it and the screws in a safe place for
reassembly later.
3. Using an assistant, carefully tip the unit onto
its back and rest on blocks to avoid damaging
the condensate drain hose and the plastic
raceway that covers the evaporator tubing on
the back of the cabinet.
4. Remove and discard the two front
brackets with leg leveler using a 5/16”
socket wrench. See Figure 1.
5. FOR GLASS DOOR MODELS ONLY -
Remove bottom door support bracket and
screw opposite the door hinge using a ⅜”
socket wrench. See Figure 2.
5/16”, 3/8” and 9/16”
Socket or Open End Wrench
Adjustable
Wrench or
Pliers
Phillips
Screwdriver
Front Bracket &
Leveling Legs
Figure 1
Door
support
bracket
Figure 2
Door Swing Reversal
(stainless steel door models)
A door reversal kit is included with reversible models. If it is misplaced, order a service kit from
Frigidaire Commercial Service Center at 1-866-738-1640.
• For right hand swing doors, order kit #5304488173.
• For left hand swing doors, order kit #5304487215.
NOTE
Only Solid Door refrigerators can be reversed. Glass Door refrigerators cannot be reversed.
Loading ...
Loading ...
Loading ...