Loading ...
Loading ...
Loading ...
Section 2 - OPERATING INSTRUCTIONS
2.1 PRE-START CHECK LIST 2.2
Make the following checks and perform the service
required before each start-up.
2.1.1. Check tires and add or release air as needed
to bring )ressure to 12 psi in front and 12 psi in rear
tires.
2.1.2. Check guards, deflectors and covers to make
sure all are in place and securely tightened.
2.1.3. Check engine oil and add oil as needed to
bring level up to the FULL mark. Refer to engine
owner's manual for oil specifications. See Figure 2.1.
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
FIGURE 2.1
2.1.4. Adjust seat as needed to most comfortable
position. Refer to Section "OPERATOR'S SEAT
ADJUSTMENT".
2.1.5. Check blade control to insure it works freely.
If blade pedals are depressed, blade lever can be
moved manually from "ON" to "OFF" to stop
blade.
2.1.6. Clean exterior surfaces of cutting deck and
engine of any accumulation of dirt, grass, oil, etc.
Keep engine air intake screen and cooling fins clear at
all times.
2.1.7. Add fuel to tank after pushing the Rear Engine
Rider outside where fumes can dissipate. Make sure
fuel filler cap is tight and vent is open after refueling.
Refer to engine owner's manual for fuel specifications.
See Figure 2.2.
OPERATOR'S SEAT ADJUSTMENT
2.2.1. FRONT TO REAR ADJUSTMENT
1. With the engine stopped, loosen the two adjusting
knobs and move seat to desired position. After
adjustment, tighten knobs securely. If seat does not
move after loosening knobs, it may be necessary to
loosen the 5/16" patch lock screws located at the rear
of the seat using a 1/2 inch wrench. See Figure 2.3.
iiiiiiiiiiiiiiiiiiiiiii! iii!iiiii iiiiiii OPERATOR'S
SEAT
iiiiiiiiiiiiADJUSTING
iiiiiiiiiiiiKNOBS !i!i iiiiii .................
iiiiiiiiiiiiiiiiii!iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii!i ........
iiiiiiiiiiiii iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii 5/16"PATCHLOCK
iiiiiiii iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii i SCREWS(DO NOT iiiiiiiiiii
iiii!iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii!i ii!Ii!IiOVERTIGHTEN) iiiiiiiiiiiiiiiiii
FIGURE 2.3
OPEN
FIGURE 2.2
Loading ...
Loading ...
Loading ...