Loading ...
Loading ...
Loading ...
14 49-2000685 Rev. 1
Installation Instructions
INSTALLING CABINET SUPPORT
FLUSHMOUNT INSTALLATION PREPARATION
(for CTW900M models only)
IMPORTANT: When installed below a single or double
oven, check to be sure that any oven supports above
the cutout do not obstruct the 22-1/2" or 23-1/2"
required depth of the warming drawer cutout.
Ŷ A 2" minimum clearance between oven and
warming drawer cutouts are required. Additional
clearance may be required if 2 x 4 blocks are used
to support runners or solid floor of the oven above.
Ŷ 7KHZDUPLQJGUDZHUPD\EHVXSSRUWHGE\HLWKHUD
solid bottom, 2 x 4 or 2 x 2 runners.
Ŷ 7KHVXSSRUWPXVWEHOHYHODQGULJLGO\PRXQWHG
flush with the bottom edge of the cutout.
There is no way to level the drawer once it has
been installed. Be sure supports are level.
Ŷ 7KHHQWLUHZHLJKWRIWKHGUDZHULVVXSSRUWHGE\
the runners or solid floor and must be capable of
supporting 150 lbs.
INSTALLATION INSTRUCTIONS
23-1/2"
2" x 4" or equivalent runners
25"
30"
22-1/2"
22"
27"
2" x 4" or equivalent runners
PREPARE THE INTERIOR
Cut and install side cleats:
Ŷ Cut side wood cleats to height of cabinet opening
and approx. 2-1/2” in depth. Install, on each side,
1-3/16” from the front face of the cabinet.
Cut and install bottom cleat:
Ŷ Cut bottom wood cleat to a height of 1-1/8”
minimum, a depth of the cabinet minus 1-3/16” and
a width of the cabinet opening (D).
Install onto the cabinet floor between the side cleats,
push it all the way back against cabinet wall and make
sure its front face aligns with the front faces of the side
cleats (1-3/16” gap from the front cabinet face).
E
C
B
D
A
A
A Side cleats depth 2-1/2” min.
B Bottom cleat height 1-1/8”
C Bottom cleat depth Cabinet depth minus E
D Bottom cleat width 28-1/2” min. – 29” max. (30”
minus 2 side cleat thicknesses of
at least 1/2” each)
E All three cleats inset
from cabinet front
1-3/16”
TOP
VIEW
Front Face of Cabinet
EE
A A
C
D
Loading ...
Loading ...
Loading ...