Loading ...
Loading ...
Loading ...
Connect Hose and Water Supply to Pump
IMPORTANT: You must attach all hoses before you
start engine. Starting engine without all hoses
connected and water supplied will damage pump.
• Attach quick connect fitting to the high pressure
hose.
Quick Connect
Fitting
/
• Uncoil high pressure hose and attach one end of
hose to the base of the spray gun with attached
quick connect. Pull down on the collar of the quick
connect, slide onto the spray gun and let go of
collar. Pull on hose and spray gun to be sure of a
tight connection.
• Attach other end of high pressure hose to the high
pressure outlet on the pump. Tighten by hand.
Before you connect your garden hose to the water
inlet, inspect the inlet screen. Clean the screen if it
contains debris or have it replaced if damaged.
Do Not run the pressure washer if the inlet
screen is damaged.
• Connect the garden hose to the water inlet. Tighten
by hand.
,_ WARNING! There MUST be at least ten feet of
unrestricted garden hose between the pressure
washer inlet and any flow shut off device, such
as a 'Y' shut-off connector or other
convenience-type water shut-off valve. Damage
to pressure washer resulting from disregarding
this warning will not be covered by the warranty.
• Turn ON the water (open supply valve completely).
,_ CAUTION! Before starting the pressure
washer, be sure you are wearing adequate
eye protection.
CHECKLIST BEFORE STARTING
ENGINE
Review the assembled unit to ensure you have
performed all of the following:
• Check that hose reel fasteners are tight.
• Check that oil has been added to proper level in
engine crankcase.
• Add proper gasoline to fuel tank.
• Check for properly tightened hose connections
(high pressure and water supply) and that there are
no kinks, cuts, or damage to the high pressure
hose.
• Provide proper water supply (not to exceed 140°F).
• Be sure to read "Safety Rules" and "Operation"
sections before using the pressure washer.
Loading ...
Loading ...
Loading ...