Loading ...
Loading ...
Loading ...
OPERATING THE THERAPURE
®
TPP630
CONTROLS/SETTINGS:
Power Control – To operate the Therapure
®
630, turn the Control Dial to turn on the
air purier. Far left is OFF.
Fan Speed Control – The Therapure
®
630 has three dierent speeds of cleaning, LOW, MED and HI.
Turn the Control Dial to cycle the settings and select the fan speed you desire.
Clean Filter Indicator Light – The Therapure
®
630 Clean Filter Indicator Light will turn Red when it's
time for the lter to be cleaned. To reset the lter indicator for 3 seconds. The CLEAN FILTER light will
ash 3 times and then turn o completely, indicating the unit has been reset.
UV Control – Press the "UV/VOC" control button for UV/VOC to turn on the UV lamp and the
photocatalyst lter.
CLEANING & MAINTENANCE
Keep the Therapure
®
630 functioning properly by cleaning the cleanable HEPA-Type Filter every four
weeks of use. More frequent cleaning will be necessary if the unit is located in an area with a high level
of airborne contaminants (excessive amounts of smoke, pet dander, etc.).
Exposing the Therapure
®
630 to candle/oil/replace soot and smoke is not recommended and will
require more frequent cleaning.
Note: Always make sure the Therapure
®
630 is turned o and unplugged before cleaning.
» Vacuuming will restore performance of the cleanable HEPA-Type Filter. However,
the lter may appear stained. This is normal and does not aect performance in any way.
» Do not use water or any household cleaners or detergents to clean the cleanable
HEPA-Type Filter.
» The inlet grill may be cleaned (after unit is turned o and unplugged) with a vacuum
or a slightly damp cloth.
Cleaning the cleanable HEPA-Type Filter
1. Release the inlet grill by pressing on the locking latch (see diagram of Main Parts).
2. Remove the inlet grill from the unit as shown below.
3. Grasp the left and right frames of the cleanable HEPA-Type Filter through the indentations
on the sides of the lter enclosure and remove the lter.
4. To clean the cleanable HEPA-Type Filter, use the brush or crevice attachment with a vacuum
cleaner. Run the attachment along the inlet and outlet side of the lter, cleaning between
the crevices as much as possible. Do not use water or any household cleaners or detergents
to clean the cleanable HEPA-Type Filter.
5. Once the cleanable HEPA-Type Filter has been cleaned and checked for any possible damage,
replace the lter back in the reverse direction described here. Plug in the unit and hold down
the UV/VOC button for 3 seconds. The clean lter light will go o and your cleaning maintenance
is done.
1.
2.
4.3.
Control
Dial
UV
Button
Clean Filter
Indicator Light
TPP630TPP630
98
Loading ...
Loading ...
Loading ...