Loading ...
Loading ...
Loading ...
RemoveDoorStop
1. Unscrew2Phillipsscrewsandremovedoorstop(A)
from refrigerator and freezer door (B). Retain all screws
for door stop replacement.
Reverse Handle (front-mounted design)
1. Remove handle screw from handle trim (A). Pry up edge
of handle trim (A & B) using a putty knife blade wrapped
in masking tape. Remove handle (C)from door by
removing 1 remaining mounting screw at each end of
handle (D).
2. Remove plugs from hinge side of door (E). Replace
plugs in empty mounting holes.
3. Mount refrigerator handle (C) on opposite side of door
using mounting screws removed in previous step.
4. Snap handle trim (A & B) into place and replace screw
at top of handle.
Reverse Freezer Handle
1. Locate two notches on back of freezer handle (A). Insert
putty knife blade wrapped in masking tape. Pry up back
edge of handle cap (B) and remove from handle.
2. Remove handle from door by removing screws (C).
A
3. Transfer plugs (D) from opposite side of freezer door to
empty mounting holes.
Replace door stop
1. Mount door stop opposite handle side on underside
of door.
To Replace Doors
1. Replace bottom hinge and shims with 3/8"hex nut
screws from hinge removal.
2. Replace bottom hinge pin (A) in hinge bracket
hole (B) toward outside of cabinet. Replace all
washer shims (C-some models).
,jjz
3. Replace center hinge and shims with Phillips screws
from hinge removal.
4. Place freezer door on bottom hinge pin.
5. Replace center hinge pin with s/16"hex nut driver.
Make sure fit is tight. Replace all washer shims _11_
(some models).
6. Assemble top hinge, hinge shim, and positioning
shim together. Attach loosely to opposite side of
cabinet to allow for door clearance.
7.
8.
Place refrigerator door on center hinge. Tighten down
top hinge to securely hold door.
Use a dime at top to space door WI6"(18 mm)
from cabinet. Handle side of door should be
approximately I/8" (3 mm) higher than hinge side.
Door will become level when it is loaded with
food.
g.
Note:
11/16"
(18mm)
Replace hinge cover.
If automatic ice maker water supply is required,
procede to Connect Ice Maker Water
Supply Line. If not, procede to section entitled
Leveling Refrigerator.
Loading ...
Loading ...
Loading ...