Loading ...
Loading ...
Loading ...
11
OPERATIONS MANUAL
BOTTLE, KEG & BACK BAR COOLERS, GLASS & PLATE CHILLERS
WIRE STORAGE BIN DIVIDER INSTALLATION (Bottle Coolers)
The standard accessory package that is supplied from the fac-
tory with your bottle cooler consists of:
MODEL
SMALL
DIVIDER
LARGE
DIVEDER
MOUNTING
SPRINGS
CAP
CATCHER
CBC37 1 1 2 1
CBC50 1 2 3 1
CBC64 1 3 4 1
CBC95 2 7 9 2
A mounting spring is provided for each bin divider (see Figure
8) to keep it in place. Before installing bin dividers, determine the
desired spacing needed for product loading, then disconnect the
cabinet from the power supply. The small dividers are provided
for installation in front of the fan motor (see Figure 6A). To
install the small divider, position it as shown and place a mount-
ing spring over the long extension wire. Insert the extension
wire into one of the bushing holes in the fan cover and push the
divider towards the cover, compressing the spring. Grasp the
divider securely and insert the front extension wire into the cor-
responding bushing hole on the interior front wall of the cabinet.
Gently release the divider and the spring will keep it in place.
Check that the divider is straight front-to-back. Install the large
bin dividers in the same manner, but in their respective bushing
holes in the evaporator cover at the back of the cabinet interior.
After all dividers are installed, reconnect power to your cabinet.
IMPORTANT WARNING: Always disconnect power to
your bottle cooler when installing or removing the small
bin divider since the long extension on the divider may
interfere with the fan , causing damage to your unit. Also
keep bottles, labels, debris, etc. away from the underside
of the fan housing, to avoid blocking the fan blade. THIS
CAN RESULT IN PREMATURE FAILURE AND VOID YOUR
WARRANTY.
INTERIOR ACCESSORIES
SHELF INSTALLATION (BBC - Back Bar Coolers)
BBC models are shipped with (2)
shelves per section and (4) clips
for each shelf (see Figure 7A for
arrangements). Pilaster strips are
secured to the cabinet walls with
special screws which allow the strips
to be easily removed for cleaning
without the use of tools. To install a
shelf, simply insert the clips into the
pilasters at the desired shelf location
and place the shelf on the clips (see
Figure 7).
SHELF INSTALLATION (CGC - Glass/Plate Chillers)
CGC24 & CGC37 models are shipped with 2 shelves (1 for
upper and 1 for lower position). CGC50 models have 4 shelves
(2 upper and 2 lower). Support angles come secured to the
front and back walls of the cabinet (see Figure 6B) for the upper
and lower positions. The supports allow the shelves to slide
side-to-side, for access to product below them. Install the shelf
in the lower position first by placing it in the cabinet with the
shelf wires running front-to-back and simply setting it down on
the lower support angles. Repeat this procedure for the upper
position.
FIGURE 7A: Shelf Layouts
FIGURE 8: CBC Bin Dividers
FIGURE 7:
Standard Shelf Pilaster
Loading ...
Loading ...
Loading ...