Loading ...
Loading ...
Loading ...
8. PREPARING THE GREASE GUN
13
8.6 REMOVING AN EMPTY GREASE
CARTRIDGE – FIGS. 6 – 7
1. Pull back on the plunger handle until the
plunger rod is fully extended.
2. Unscrew the grease tube assembly from the
pump assembly.
3. Carefully release the plunger handle to eject
the empty cartridge from the container tube.
8.7 FILLING GUN FROM A BULK
CONTAINER
1. Remove the pump assembly from the grease
tube assembly
2. Insert the open end of the grease tube
assembly into the bulk container. Slowly pull
the plunger handle back while pushing the
grease tube assembly deeper into the lubricant
to prevent air pockets.
3. Assemble the pump assembly onto the grease
tube assembly. Disengage the plunger rod
from the plunger by depressing lock lever. Push
the plunger rod into the grease tube assembly.
8.8 AIR POCKET VALVE – FIG. 8
With grease in the grease tube assembly, press the
gun trigger until grease flows from the hose.
Frequently depress the vent valve to expel any
air pockets.
For further information and guidance on how to
remove air pockets, see section 10 Troubleshooting
on page 15.
8.9 PRESSURE RELIEF VALVE – FIG. 9
Pressure relief is factory preset at 10,000psi+/- 500
psi. If back pressure in the grease line exceeds the
preset limit, grease will then be expelled from this
valve to reduce risk of motor overload and limit
excessive grease pressure in grease hose. Do not
exceed specifications or alter gun to perform
beyond ratings. Such misuse will void warranty and
can cause possible injury.
CAUTION: DO NOT ADJUST RELIEF PRESSURE.
FIG.8
FIG.9
FIG.6
FIG.7
r
e
t,
Loading ...
Loading ...
Loading ...