Loading ...
Loading ...
Loading ...
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have nished.
37
11. Servicing
n
Disconnect the cooker from the electricity supply
before servicing, particularly before removing any
of the following: control panel, side panels, ceramic
hob, or any of the electrical components or cover
boxes.
n
Before reconnection, check that the appliance is
electrically safe.
1. Panels
1.1 To Remove the Control Panel
n
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Removing the Control Panel
Pull o all the control knobs and remove the xing screws
underneath the control panel.
The control panel will drop down slightly. It is held at the top
by two holes in the top edge, one at each end, that locate on
the tags on the inner panel. Lift the control panel clear of the
tags and pull forwards, taking care not to damage or strain
the wiring.
1.2 To Remove the Side Panels
n
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Remove the control panel (see 1.1). Pull the cooker forward.
Remove the 4 retaining screws for each panel (1 at the front
base, 1 on the top and 2 at the rear).
Reassemble in reverse order.
2. Hotplates
2.1 To Lift up the Ceramic Hob
n
DISCONNECT FROM ELECTRICITY SUPPLY.
Pull o the push t control panel end caps at each end and
remove the end xing screws under the end cap.
Remove the lower front retaining screws (one each side)
situated beneath the lower edge at the front corners of the
side panels.
Swing the side panels to gain access to the hob xing screws
(1 each side) at the top front of the side uprights.
Remove these screws.
Lift up the ceramic hob at the front and prop into position
with a non-metallic prop.
n
CAUTION: THE CERAMIC HOB MATERIAL IS
MUCH MORE SENSITIVE TO SCRATCHES ON THE
UNDERSIDE THAN THE TOP.
Take care not to touch or scratch the underside of the ceramic
as this will weaken the material and cause the top to shatter.
3. Controls
3.1 To Replace the Light Switch
n
DISCONNECT FROM ELECTRICITY SUPPLY.
Remove the control panel (see 1.1).
Note: The old switch may be destroyed during removal.
Remove the old switch from its bezel by gripping the switch
body behind the control panel and twisting sharply. Remove
the switch bezel by folding back its locking wings and
pushing forward. Fit the new bezel to the control panel by
rst lining up the raised key on its body with the cut-out in
the control panel and pushing it in from the front.
Assemble the new switch to the bezel by lining up the key
sections and pushing home. Fit the new button by pushing in
from the front. Replace the Control Panel in reverse order and
test for correct operation.
3.2 To Remove the Electronic Timer
n
DISCONNECT FROM ELECTRICITY SUPPLY.
Remove the control panel (see 1.1). Pull o the timer control
button(s).
Remove the timer/mounting bracket assembly from the
control panel by removing the xing screws.
Remove the timer from its mounting bracket by depressing
the plastic lugs on the timer case, at the same time pulling
the unit forward. Reassemble in reverse order. When
replacing the leads, refer to the wiring diagram in this
manual. Check the operation of the timer.
Loading ...
Loading ...
Loading ...