Loading ...
Loading ...
Loading ...
Using your Dishwasher..continued
"Refill Rinse Aid" Indicator
Fill the Rinse Aid dispenser when the Refill Rinse Aid message
comes on as shown in Figure 23.
b) Wait at least ten seconds or until water noises stop before
opening the dishwasher door.
c) To resume the cycle, shut the dishwasher door and press the
On/Off button.
23
6. Canceling or Changing a Cycle
a) To cancel or change a cycle, press and hold for three seconds
the two buttons labeled "Cancel Drain" as shown in Figure 25
until the digital readout shows "0".
4. "Sanitized" Indicator
The Sanitized indicator appears on the control panel display as
shown in Figure 24.
24
When the Sanitized indicator lights, it means that your dishes
have been sanitized according to very strict standards of wash
time and water temperature. The standards for sanitization are set
by the National Sanitation Foundation (NSF) and are explained
in the document ANSIINSF 184, Residential Dishwashers. More
information on NSF standards is available at the NSF website
http://www.nsfconsumer.org/home/appliances.asp.
The dishwasher cycles that are NSF certified are Scrub Wash,
Normal Wash, and China Gentle. When these cycles are
complete, the "Sanitized" indicator on your dishwasher control
panel will illuminate.
Note: If your household water supply is too hot, your dishwasher's
heating time may be reduced and the "Sanitized" light or symbol
may not illuminate. Your dishwasher Installation Manual has
information on the recommended temperature for your household
hot water supply.
5. Interrupting a Cycle
NOTE: Should you need to interrupt a cycle (to add or remove an
item, to add detergent, etc.), it is best to do so within the first 30
minutes of the cycle.
a) Press the On/Off button to stop the dishwasher.
SCALD HAZARD: You could be seriously scalded if you
open the dishwasher door quickly during a wash or rinse
cycle. Do not fully open the dishwasher door for at least
10 seconds after the dishwasher has stopped, or until
water noises stop.
b) Wait for approximately one minute, then press the On/Off
button
c) You may now begin a new cycle.
E. Wash Cycle Options
1. Top Tier Only TM Cycle
This option allows you to save energy and water by washing
loads small enough to fill only the top rack.
Note: The Top Tier Only option does not reduce wash time.
To use the Top Tier Only cycle
a) Load the top rack.
b) Press the On/Off button.
c) Press the button for the desired wash cycle.
d) Press the Top Only button.
2. Delay Start
This option allows you to delay the start of the selected wash
cycle for up to 24 hours.
a) Press the OnlOff Button
b) Press and hold for three seconds the Delay Start button as
shown in Figure 26 until the LED display shows the number of
hours of delay desired.
26
c) Press the button for the desired wash cycle. You can change
the delay time and/or the cycle at any time during the delay.
12 Adding Detergent and Rinse Aid Operating the Dishwasher
Loading ...
Loading ...
Loading ...