Loading ...
Loading ...
Loading ...
• 4 •
3. OPERATING INSTRUCTIONS
3.1 To insert batteries (3 AAA, not included), remove the three screws on the back and
open the case. When nished, close the case, replace and tighten the screws.
3.2 Use the magnet on the back, to attach to any magnetic metal surface.
3.3 The LED Road Flare is waterproof. It may be safely used for marine applications and
in wet environments, and submerged to a depth of 33 feet. It will oat unless secured.
3.4 Press the
light mode selector
to rotate through the following 9 light patterns:
1. Rotate
2. Quad ash
3. Single blink
4. Alternating blinks
5. SOS rescue (Morse code)
6. Steady on: high
7. Steady on: low
8. 2 LED Flashlight
9. 4 LED Flashlight
10. OFF
3.5 Alternate operation: To turn off the are without cycling through the 9 light patterns,
press and hold the light mode selector for 2 seconds. Two LEDs will ash ve times
and then turn off. When ready to operate again, press th light mode selector and it
will return to the last ash pattern that was selected before turning off.
3.6 Press the
ON/OFF power
button to turn the center warning lights on and off.
4. MAINTENANCE AND STORAGE INSTRUCTIONS
4.1 Store inside, in a cool, dry place.
4.2 Do not use alcohol, ammable solutions, or other solvents on or near this unit.
Clean only with warm water and a soft cloth.
4.3 Any servicing should be performed by qualied service personnel.
5. TROUBLESHOOTING
PROBLEM SOLUTION
The are does not operate. Make sure the batteries are inserted correctly.
Replace the batteries, if necessary.
Loading ...
Loading ...
Loading ...