Loading ...
Loading ...
Loading ...
$ERVnCE AND ADJUSTMENTS
3"0 REPLACE MOTBON DRIVE BELT
(See Fig. 29}
Park the tractor on level surface. Engage parking brake.
For ease of service there is a belt installation guide decal on
bottom of left footrest.
Remove mower (See "TO REMOVE MOWER" in this
section of this manual.)
BELT REMOVAL -
= Engage parking brake (creates slack in bait).
Remove belt from clutching and fan idler pulleys.
Loosen belt keeper above transaxle pulley.
= Remove belt from transaxle pulley.
Remove belt from engine pulley and front V-idier pul-
ley.
, Pu!l belt out of all belt keepers and remove from tractor.
BELT INSTALLATION -
Place V part of belt into grooves on engine pulley and
front V-idler, making sure to route belt inside of all belt
keepers.
Route belt on right side, coming from V-idler, towards
back of tractor, above midspan belt keeperand to top
of transaxle pulley.
, Route belt on left side, coming from engine pulley,
towards back of tractor and through loop in midspan
belt keeper.
Place V part of belt into grooves on transaxte and fan
idler pu}leys, making sure to route belt inside of all belt
keepers.
, Retighten belt keeper above transaxle pulley.
• Place belt around clutching idiers as shown, making
sure to route belt inside of all belt keepers.
® Check to be sure belt is positioned correctly and is on
proper side of all belt keepers,
• Reinstall mower.
IMPORTANT: CHECK BRAKE ADJUSTMENT.
TRACTOR V-BELT DRIVE SCHEMATIC
VIEWED FROM L.H. SIDE OF TRACTOR
CLUTCHING TRANSAXLE
CLUTCHING IDLER BELT
FLAT IDLER _ER
ENGINE ABOVE BELT
PULLEY
V-IDLER KEEPER
BELT
AS VlEWED FROM BOTTOM
BELT
TWISTS
BELT
KEEPER
FAN
iDLER
"TO ADJUST MOTION CONTROL LEVER
(See Fig. 30)
The motion control lever has been preset at the factory and
adjustment should not be necessary.
If for any reason the motion control lever will not hold its
position whiie at a selected speed, it may be adjusted at the
friction pack located on the right side of chassis.
° Park tractor on level surface. Stop tractor by turning
ignition key to "OFF" position and engage parking
brake.
- Place motion control lever in neutral (N) position.
While holding locknut, loosen iam nut
• Tighten tocknut 1/4 turn.
While holding Iocknut, tighten jam nut securely.
NOTE: If for any reason the effort to move the motion
control lever becomes too excessive, reverse the above
adjustment procedure by loosening Iocknut 1/4 turn.
Road test tractor after adjustment and repeat procedure if
necessary.
LOCKNUT
JAM NUT
FiG. 30
TRANSMISSION REMOVAL/REPLACEMENT
Should your transmission require removal for service or
replacement, it should be purged after reinstaltation before
operating the tractor. See "PURGE TRANSMISSION" in
Operation section of this manual.
TO ADJUST STEERING WHEEL ALIGNMENT
If steering wheel crossbars are not horizontal (left to right)
when wheels are positioned straight forward, remove steer-
ing wheel and reassemble per instructions in the Assembiy
section of this manual.
FIG. 29
2,$
Loading ...
Loading ...
Loading ...