Loading ...
Loading ...
Loading ...
Moving cars
1. Unplug the power supply cord.
2. Close shutoff valve in gas supply line.
3. Disconnect gas supply line pipe and remove fittings attached
to dryer pipe.
4. Cap the open fuel supply line.
5. Make sure leveling legs are secure in dryer base.
6. Use masking tape to secure dryer door.
2. Open the dryer door. Locate the light bulb cover on the back
wall of the dryer. Remove the screw located in the lower right
corner of the cover. Remove the cover.
The dryer light automatically turns on inside the dryer drum when
you open the door.
To change the drum light 3. Turn bulb counterclockwise. Replace the bulb with a 10-watt
appliance bulb only. Replace the cover and secure with the
1. Unplug dryer or disconnect power, screw.
4. Plug in dryer or reconnect power.
TROUBLESHOOTING
Firsttry the solutions suggested here and possibly avoid the cost of a service call...
Dryer will not run
• Has a household fuse blown, or circuit breaker tripped?
Replace the fuse or reset the circuit breaker. Ifthe problem
continues, call an electrician.
Was a regular fuse used?
Use a time-delay fuse.
msthe dryer door firmly closed?
Was the Start button firmly pressed?
Large loads may require pressing and holding the Start
button for 2-5 seconds.
No heat
Has a household fuse blown, or has a circuit breaker
tripped?
The drum may be turning, but you may not have heat.
Replace the fuse or reset the circuit breaker. Ifthe problem
continues, call an electrician.
Unusual sounds
• Has the dryer had a period of non-use?
If the dryer hasn't been used for a while, there may be a
thumping sound during the first few minutes of operation.
• msit a gas dryer?
The gas valve clicking is a normal operating sound.
msa coin, button, or paper clip caught between the drum
and front or rear of the dryer?
Check the front and rear edges of the drum for small objects.
Clean out pockets before laundering.
Are the four legs installed, and is the dryer level front to
back and side to side?
The dryer may vibrate if not properly installed. See the
Installation Instructions.
• is the clothing knotted or balled up? When balled up, the
load will bounce, causing the dryer to vibrate. Separate the
load items, and restart the dryer.
• Is the valve open on the gas supply line? Dryer displaying code message
"PF" (power failure), check the following:
Was the drying cycle interrupted by a power failure?
Press and hold START to restart the dryer.
"F" Variable (F1, F2, F20) service codes:
Call for service.
21
Loading ...
Loading ...
Loading ...