Hunter 50730 Crescent Falls 44" Galvanized Integrated LED Ceiling Fan

User Manual - Page 9

For 50730.

PDF File Manual, 12 pages, Read Online | Download pdf file

50730 photo
Loading ...
Loading ...
Loading ...
8
1886
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Remote Troubleshooting
Installing the Glass
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
NOTE: Check to ensure
proper engagement.
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
Notch
Tab
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Assembling the LIght Kit
Insert the third screw, found
in the hardware bag, into
place and then tighten all three
screws.
Feed the wires through the
center hole of the upper switch
housing, then wrap keyhole
slots around the screws and
twist clockwise.
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light xture.
2 of 3
Light Kit Screw
BAG
1 of 3
Light Kit Screw
BAG
Partially install two of the light kit screws
found in the bag. It does not matter
which two screw holes you choose. Connect
the single-pin connectors from the LED
assembly to the connectors from the fan.
Connect the white wires together. Connect
the blue and black wires together.
Turn the light kit clockwise until the light kit
screws are rmly situated in the narrow end
of the keyhole slots. Install the third screw and
tighten all three screws securely.
2 of 3
1 of 3
Short Light Kit
Screw
Short Light Kit
Screw
BAG
BAG
Align the keyhole slots in the light kit
housing with the two screws. Make
sure all the wires from the fan and the
light kit are snug inside the center of
the light kit, not pinched in between
the upper switch housing and the light
kit or hanging out of the sides.
Partially install two light kit
screws, found in the
hardware bag, through the gasket
halfway into the motor housing as
shown. It does not matter which
two screw holes you choose.
Loading ...
Loading ...
Loading ...