Loading ...
Loading ...
Loading ...
Toenhancetheappearanceandmaintainperformance
the refrigeratorshouldbe levelin accordancewith the
followinginstructions.
Note
, Complete any required door reversal, panel
installation and/or a water supply connection,
before leveling.
Materials Needed
, _X,"hex head driver
, Carpenter's level
1. Remove toe grille.
, Grasp firmly and pull bottom
outward to unclip.
2. Remove bottom bracket cover(s}.
, Place the eraser end of a pencil or similar blunt
tool in the cover notch.
Notch
Location
, Use slight pressure to pry the
cover loose.
Continue to maintain
downward pressure to the
notched side of the cover while
swinging it off.
3. Using hex head driver, turn front adjustment
screws (A} clockwise to raise and counterclockwise
to lower the front of the refrigerator.
Some models only have adjustment screws "A_"
Select models also have rear adjustment screws
(B}. Using the hex head driver, turn each of these
adjustment screws (B} to raise or lower the rear of
the refrigerator.
Using the carpenter's level, make sure front of
refrigerator is '/4" (6 ram} or K bubble higher than
back of refrigerator and that the refrigerator is level
from side to side.
If required, correct rocking of refrigerator by
turning rear adjustment screw clockwise to raise
rocking corneE If doors are uneven, do the
following:
Determine which
door needs to be
raised.
Turn front roller
adjustment screw (A}
clockwise to raise
front corner of door.
If one refrigerator door has reached the limit of
its adjustment range and doors are still not level,
raise or lower the opposite door by turning roller
adjustment screw counterclockwise.
Check with level to verify '/9" tilt to the back for
proper door closure.
If refrigerator is aligned and stable, replace toe
grille and hinge covers.
Z Replace bracket cover(s}.
Position cover into the outer edge of the hinge.
Swing the cover toward the cabinet and snap it
into place.
8. Replace the toe grille.
, For proper reinstalhtion, ensure the "top" marking
on the interior of the toe grille is oriented correctly.
. Align the toe grille mounting clips with the lower
cabinet slots.
, Push the toe grille firmly until it snaps into place.
Loading ...
Loading ...
Loading ...