Loading ...
Loading ...
Loading ...
3
Step 1: Attaching the Seal
To install the seal, locate the words “Up” or “Top” and face them
towards the main body. Slip the seal over the foot pad, at side down
towards the pool oor and pull gently until it seats itself on the other
side in its groove as illustrated in Figure 2.
Seal must be installed at side down, pleated side up. Once in
place, the seal should rotate and turn freely.
The seal is not reversible. The raised pleats on the pleated seal must
face upward. The at side of the seal should face down to rest against
the pool surface.
Step 2: Attaching the Adapter
The adapter is tted onto the body, see diagram.
NOTE: This step is applicable only to models A and C
Step 3: Attaching the Roller Bumper Strap
Insert the bottom end of the strap into the slot provided on the main body. Insert
the top end of the strap into the locking clip attached to the swivel head. See
Figure 3.
Step 4: Attach the Dive Float Restrictor
Insert the bottom end of the strap into the slot provided on the main body. Insert
the top end of the strap into the locking clip attached to the swivel head. See
Figure 3.
Step 5. Attach the Hose Weights and Assemble the Hose
The cleaner hose comes in sections that must be assembled. You will
need enough sections to reach from where the cleaner is connected, to the
farthest end of your pool, plus an extra section. You will have to attach hose
weights to the hose to neutralize the hose’s buoyancy in the water. The
number of hose weights required is determined by the maximum depth of
your pool. The deeper the pool the more weight will be needed. See Table
A to determine how many hose weights your pool will require.
ASSEMBLY
Loading ...
Loading ...
Loading ...