Loading ...
Loading ...
Loading ...
8. If tape holds bottom drawer cover to drawer
supports, remove the taper Pull drawer partway out.
Reach in, push the rear of the glass up and, at the
same time, back, until it clears front-corner retainers.
9. Tilt and remove the cover°
10. Tilt and remove the drawer.
After cleaning, replace drawers and covers in
reverse order. Reinstall the gasket at the rear of the
top drawer° Fit the end of
the plastic drawer support
into the slot on the gasket,
with the rubber gasket
flap facing you° Make
sure the gasket snaps
into p,ace. __
Then replace the light
panel by hanging top of
panel on upper pins and ..:_.':
pushing in at bottom. ...
Drain Opening in Freezer Compartment
When cleaning, remove 1
the freezer bin and flush
a solution of baking soda
(one teaspoon) and two
cups of hot (not boiling)
water through the drain
line with the help of a
meat baster. This will
help eliminate odor and
reduce the likelihood of a clogged drain line.
tf drain becomes clogged, use a meat baster and
baking-soda-and-water solution to force the clog
through the drain line.
Condenser
The condenser is located
behind the base grille. For
most efficient operation,
remove the base grille
(see page :3)and sweep
away or vacuum up dust
that is readily accessible. For best results, use a
brush specially designed for this purpose. It is
available at your Sears store or service center. This
easy cleaning operation should be done at least
once a year.
13
Behind Refrigerator
Take care moving your refrigerator away from the
watt. All types of floor coverings can be damaged,
particularly cushioned coverings and those with
embossed surfaces. Pull the refrigerator straight out
and return it to position by pushing it straight in.
Moving refrigerator in a side direction may damage
floor covering or refrigerator.
Light Bulb Replacement
Unplug refrigerator before changing a light bulb.
Fresh Food Compartment--Upper Light
1. Pull bottom of light
panel down about 1/4"-
just enough to disengage
lip at rear from grooves
in retainers an rear wallo
2. Lift panel to disengage
top from tabs on control
housing, and remove
panel.
After replacing with same
size bulb, reinstall panel
(hang top on tabs; pull
bottom down and push it
back, and release it to
let tip engage grooves in
retainers)°
Fresh Food Compartment--Lower Light
1. Remove light panel. See Storage Drawers, Step 3,
on page 12.
:2. After replacing the appliance bulb with a same-
size bulb, replace light panel by hanging top of panel
on upper pins, then pushing in at bottom_
Freezer Compartment
1. Remove shelf just
below light panel. (Shelf
will be easier to remove
if it is emptied first.)
2. Pull plastic light panel toward you. (It will bend to
free tabs from grooves_)
3. After replacing with same size appliance bulb,
reinstall panel and shelf.
Loading ...
Loading ...
Loading ...