Loading ...
Loading ...
Loading ...
5
INSTALLATION INSTRUCTIONS
Before Using your Appliance
• Remove the exterior and interior packaging, but do not remove any foam insulation surrounding
the pipes at the back.
• Before connecting the unit to the power source, let it stand upright for approximately 24 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
• Place the unit on a flat, solid floor that is strong enough to support it when it is fully loaded. To
level the appliance, adjust the rolling casters at the bottom of the unit.
• When moving your refrigerator, please do not incline it more than 45 degrees.
• Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the unit to perform
improperly. The optimal ambient temperature range is S0°F - 109 .4°F. Do not mount the draft
tower remotely, as the exposed beer line will not be refrigerated, causing foam. Avoid locating
the unit in damp areas.
• Unwind the power cord to its full length and inspect for damage before plugging into the outlet.
• Plug the refrigerator into an exclusive, properly installed and grounded wall outlet. Do not under
any circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or electrical grounding should be directed to a certified electrician or
authorized products service center. After plugging the appliance into a wall outlet, allow the unit
to cool down for 3 to 4 hours before installing a keg in the appliance.
Locating your Appliance
• The Kegerator is designed from built-in or freestanding installation and is suitable for indoor and
outdoor use.
• For freestanding installation, 5” (127mm) of space at the back and sides of the unit and 4”
(102mm) at the top are suggested, which allows the proper air circulation to cool the compressor
and condenser for energy saving. Even for built-in installation, it is a must to keep at least 3/16”
(5mm) of space on each side, 2” (50mm) at the back and 1/16” (1.6mm) at the top to ensure
proper service access and ventilation. The air vent at the front of the appliance must never be
covered or blocked in any way.
Guardrail Installation
1. Place the guardrail on top of the beer dispenser and line up the feet with the holes on top of the
cabinet
2. Using the screws provided, secure each foot to the cabinet.
Loading ...
Loading ...
Loading ...