Loading ...
Loading ...
Loading ...
13
Custom Panel Dimensions
36" Built-In Refrigerator
Custom Door Panel Dimensions
Using Trim Kit ZKT36
3/4" thick panel with custom handle
and/or ZWCD1 custom collar trim
Detail B
Rout panels to specification below on
the handle side of each panel
Important:
Maintain 1-1/2" min. gap between
top of doors and bottom of grille panel.
Grille Panel height can vary to fill installation
height.
Installation Height Dimension A
83" 8-1/4"
83-1/2" 8-3/4"
84" 9-1/4"
84-1/2" 9-3/4"
ZISW36D (white dispenser)
ZISB36D (black dispenser)
• ZKT36 and ZKHT1 installed together provides for the
installation of 3/4" custom door and grille panels, using
a custom handle of your choice. Cut panels to size, rout
the handle side of the panels as shown below and install
(see detail B).
• For ZKHTSS1 tubular stainless steel handle kit, cut panels
to size and rout the handle side of the panels as shown in
detail B.
• For standard dispenser trim: Cut panels to size, rout the
handle side of the panels as shown in detail B, rout the
bottom of the upper freezer panel and the top of the lower
freezer panel to allow placement of support brackets (see
detail A) and install.
• For custom dispenser trim ZWCD1 kit must be used: Cut
panels to size, refer to detail C for dispenser cutout
routing instructions. When a raised panel design is used,
a custom middle rail is required. A 14-1/2" wide middle rail
must be used because the custom collar trim must be
located within the raised portion of the panel. This area
must be 3/4" thick. See detail D for raised panel design
requirements.
• When using the standard full-width dispenser trim, the
length of the custom handle, top to bottom cannot exceed
11-3/4". Locate the handle a minimum of 3/4" and a
maximum of 1-1/2" from the edge of the panel. There are
no length restrictions on handles for models using a
custom collar dispenser trim (ZWCD1).
1 13/16"
1 13/16"
1/4"
max
Freezer Door FaceFreezer Door Face
Fresh Food Door Face
Detail A
Upper
Freezer
Panel
Lower
Freezer
Panel
Panel
Face
1"
1"
3/32"
CUSTOM PANEL
DIMENSIONS
16 11/16"
37"
2 9/16"
67 15/16"
19 5/16"
17 11/16"
Fresh Food
Panel
Freezer Panel
Standard
Dispenser
Freezer Panel
Custom
Dispenser
15 5/16"
15 5/16"
9 7/16"
12 5/16"
7/8"
Wide
Rout
The Cutout is 9 7/16" wide
by 12 5/16" high. 3/4" panels
must be routed on all four
sides of the cutout. Rout
the back side of the panel
1/4" deep. 7/8" wide
(shaded area).
Detail C Custom
Dispenser Cutout
Custom Grille Panel
35 1/2"
A
Over 1/4" Thick (3/4" max) Panel
Important: Maximum weight for fresh food panels is
50 pounds and 30 pounds for freezer door panels.
Hole is
Cut
After Door
Fabrication
14 1/2"
Wide
Middle
Rail
Detail D
Raised Panel Design
Handle
Side
A
A
Section AA
*Custom Stiles and
Middle Rail Required
*3" Stiles
Left Side
*2-3/16" Stiles
Right Side
Loading ...
Loading ...
Loading ...