Loading ...
Loading ...
Loading ...
7=
Place assembled gun and wand on pressure
washer holder.
=
Place pull cord into the wire bracket holder.Pull the
cord under the wire bracket to the right of the wire
loop. Lift the pull cord handle up and slide the
cord to the left, sliding the cord into the wire loop.
Next slide handle behind the wire bracket to the
left of the wire loop. Engine recoil will pull the cord
into its final position.
Checklist
Before going any further please review the following:
• Be sure you have completed assembly instructions.
Double check all fittings to be sure they are tight.
IMPORTANT: Before any attempt to start your pres-
sure washer be sure to check engine oil (See Opera-
tion under Engine Oil.)
Know Your High Pressure Washer
Read this Owner's Manual and Safety Rules
before operation of your High Pressure Washer
Compare this illustration with our pressure washer to
familiarize yourself with the location of various con-
trols and adjustments. Save this manual for future
reference.
SPRAY GUN HANDLE
ASSEMBLY
HiGH PRESSURE
HOSE
GAS TANK/CAP
PUMP- Develops high pressure.
PRESSURE REGULATOR- Allows you to adjust the CHOKE
pressure of the outlet stream.
ENGINE RUN/STOP SWITCH- Sets engine in starting
mode for recoil starter -- Stops running engine.
RECOIL STARTER- Used for starting the engine
manually.
SPRAY GUN ASSEMBLY (Contains Gun and Wand}-
Controls the application of water onto cleaning surface
with trigger device.
OIL FILL- Port where engine oil is poured.
GAS TANK/CAP- Cap is removed and unleaded PRESSURE
gasoline is poured. REGULATOR
CHEMICAL INJECTION TUBE AND FILTER- Mixes
water and detergent in outlet water flow.
HIGH PRESSURE OUTLET- Connection for high pres-
sure hose.
CHOKE- Lever used for starting unit.
STO P/START
HIGH
PRESSURE
OUTLET
CHEMICAL
INJECTOR
TUBE & FILTER
WATER INLET
CONNECTION
RECOIL
STARTER
OIL FiLL
Loading ...
Loading ...
Loading ...