Loading ...
Loading ...
Loading ...
TROUBLESHOOTING 4.6
Ice & Wafer
Water is not
dispensing.
Dispensing
,warm water.
t i i i iS_ i i
New installation or water line
recently connected.
The dispenser panel is locked.
The dispenser is not set for water
dispensing.
Refrigerator or freezer doors are not
closed properly.
Water filter has been recently
removed or replaced.
Tubing connecting refrigerator to
house supply valve is kinked.
iiiii iiiiii!i i ii !i iiiiiiiiiiii i iiii i!IIiiiiii i iiiiii iiiiiiiii;:iiIi iiiiii i@iiiiiii! iii iii iiiiiiii iiiiii iiiiiiii iiiWIiii i iiiii iiiiii illiiii ili i!
Dispense 2.5 gallons of water (flush for
approximately 5 minutes) to remove trapped
air and contaminants from the system. Do
not dispense the entire 2.5 gallon amount
continuously. Depress and release the
dispenser pad for cycles of 30 seconds ON
and 60 seconds OFR
Press and hold the Lock button for three
seconds to unlock the control panel and
dispenser.
The dispenser can be set for ice or water.
Make certain that the control panel is set for
the proper operation. Press the Water button
on the control panel to dispense water.
Water will not dispense if any of the
refrigerator doors are left open.
After the ,water filter is replaced, dispense
2.5 gallons of water (flush for approximately
5 minutes) to remove trapped air and
contaminants from the system. Do not
dispense the entire 2.5 gallon amount
continuously. Depress and release the
dispenser pad for cycles of 30 seconds ON
and 60 seconds OFR
The tubing can kink when the refrigerator
is moved during installation or cleaning
resulting in reduced water flow. Straighten
or repair the water supply line and arrange it
to prevent future kinks.
The house water supply is not Connect the refrigerator to the water supply
connected, the valve is not turned on and turn the water shutoff valve fully open. If
fully, or the valve is clogged, the problem persists, it may be necessary to
Refrigerator ,was recently installed.
The water dispenser has been used
recently and the storage tank ,was
exhausted.
Dispenser has not been used for
several hours.
Refrigerator is connected to the hot
water supply.
contact a plumber.
Allow 24 hours after installation for the
,water storaqe tank to cool completely.
Depending on your specific model, the
,water storage capacity will range from
approximately 20 to 30 oz.
If the dispenser has not been used for
several hours, the first glass dispensed may
be warm. Discard the first 10 oz.
Make sure that the refrigerator is connected
to a cold water pipe.
WARNING: Connecting the refrigerator to a
hot water line may damage the icemaker.
Loading ...
Loading ...
Loading ...