Loading ...
Loading ...
Loading ...
Yournewtractorhasbeenassembledatthefactorywithexceptionofthosepartsleft
unassembledforshippingpurposes.Toensuresafeandproperoperationofyourtractor
allpartsandhardwareyouassemblemustbetightenedsecurely.Usethecorrecttools
asnecessaryto insurepropertightness.Reviewthevideocassettebeforeyoubegin.
TOOLS REQUIRED FOR
ASSEMBLY
- A socket wrench set will make assembly
easier. Standard wrench sizes you need
are listed below.
(1) 9/16" wrench
(1) 3/4" wrench
(2) 1/2" wrench
(1) Phillips Screw driver
(1) Tire pressure gauge
(1) Utility knife
(1)Pliers
(1) 3/4" Socket
w/drive rachet
When right or left hand is mentioned in
this manual, it means, from your point of
view, when you are in the operating posi-
tion (seated behind the steering wheel).
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
• Remove all accessible loose parts and
parts boxes from shipping carton (See
page 6).
• Cut, from top to bottom, along lines on
all four corners of shipping carton, and
lay panels flat.
• Check for any additional loose parts or
boxes and remove.
BEFORE ROLLING TRACTOR OFF
SKID
ATTACH STEERING WHEEL
ASSEMBLE EXTENSION SHAFT AND
BOOT
• Slide extension shaft onto lower steer-
ingshaft. Align mounting holes in exten-
sion and lower shafts and install 5/16
hex belt and Iocknut. Tighten securely.
IMPORTANT: Tighten bolt and nut secure-
ly to 18-22 ft. Ibs. torque.
• Place tabs of steering boot over tab
slots in dash and push down to secure.
iNSTALL STEERING WHEEL
• Position front wheels of the tractor so
they are pointingstraight forward.
• Slide steering wheel adapter onto steer-
ing shaft extension.
• Position steering wheel so cross bars
araJ_rizontal (left to right) and slide
inside boot and onto adapter.
• Assemble large flat washer, 3/8 lock
washer, 3/8 hex belt and tighten securely.
• Snap steering wheel insert into center
of steering wheel.
• Remove protective materials from trac-
tor hood and grill.
IMPORTANT: Check for and remove any
staples in skid that may puncture tires
where tractor is to roll off skid.
Insert
,_3/8 Lockwasher
_Lt_rgherFlat
Wheel
Extension Adapter
TO ROLL TRACTOR OFF SKID (See
Operation section for location and
function of controls)
• Press lift lever plunger and raise attach-
ment lift lever to its highest position.
• Release parking brake by depressing
clutch/brake pedal.
• Place freewheel control in freewheeling
position to disengage transmission (See
"TO TRANSPORT" in the Operation
section of this manual).
• Roll tractor forward off skid.
• Remove banding holding discharge
guard up against tractor.
8
Loading ...
Loading ...
Loading ...