Loading ...
Loading ...
Loading ...
8 49-50323
Installation Instructions
INSTALLATION INSTRUCTIONS
COLD WATER SUPPLY FITTING
(CONT.)
B. OPTIONAL HOME INSTALLATION
(Where codes permit)
Saddle Valve: Saddle valve must be able to
connect with 1/4-inch tubing supplied with
the system. Not supplied with product; check
your local hardware or home service store for
SURGXFW6DGGOHYDOYHW\SLFDOO\UHTXLUHVƎ
OD tubing or larger.
NOTE: Codes in certain states require
installation by a licensed plumber and do
not permit the use of the saddle valve. For
installation, use plumbing code 248-CMR of the
Commonwealth of Massachusetts.
1. Turn off the cold water supply and install saddle
valve as required by product selection. (Be sure
to follow manufacturer’s installation instructions.)
NOTICE: If hole is required to be drilled
in pipe, to protect yourself from serious
injury or fatal shock, use a battery-
powered hand drill only to make the hole.
DO NOT USE AN ELECTRIC DRILL.
2. Open saddle valve after complete system has
been installed.
C. OPTIONAL INSTALLATION
(For installation with rigid pipe between supply
valve and sink faucet)
Option 1
1. Remove pipe from supply valve and sink faucet.
2. Obtain flexible pipe sized to your plumbing.
3. Install flexible pipe.
4. Go back to A. Preferred Installation section
step 3.
Option 2
1. Obtain compression fittings to fit rigid pipe.
2. Obtain any other fittings required to connect
compression fittings to feed water adapter.
3. Remove pipe from supply valve.
4. Cut pipe to fit length of assembled fittings and
adapter.
5. Install compression fitting to pipe.
6. Go back to A. Preferred Installation section
step 3.
NOTE: Above described materials are not
included with the product.
INSTALL THE FAUCET
Be sure there is room underneath and above the
sink to make the needed connections. Before
starting, make sure there is sufficient room for the
faucet base and unit. Select one of the following
places to install the faucet:
A. In an existing sink spray attachment or soap
dispenser hole.
B. In a hole to be drilled in the sink top.
C. In a hole to be drilled in the countertop, next
to the sink.
NOTES:
• Be sure the faucet base will fit flat against the
surface at the selected location so the bottom
gasket between the base and surface area will
seal.
• Make sure to leave enough clearance at the back
of the faucet in case you need to remove it. The
installation of the butterfly bracket is slightly off to
center of the base. When drilling, make sure to
take this offset into account with hole placement.
Installation Steps (refer to illustration below
for clarification)
,IGULOOLQJLVQHHGHGPDNHDƎGLDPHWHUKROH
Be sure to use the proper procedure for
drilling stone, porcelain or stainless steel.
Special drill bits may be needed. Consult a
qualified plumber for the proper procedure.
CAUTION
When drilling in Stainless Steel,
edges may be sharp and could puncture the tube.
Be careful to not cut yourself or damage the tube.
2. Remove the faucet body and base by turning the
base counterclockwise.
3. Remove the butterfly bracket from the screw.
Then insert the screw into the top of the base and
reattach the butterfly bracket.
4. Align the gasket to cover the hole completely.
Then place the butterfly bracket on the base into
the hole.
5. Tighten the screw to secure the butterfly bracket
to the underside of the sink top. The base should
be firmly in place and should not wobble or turn.
Base
Sink
Gasket
Butterfly Bracket
Screw
Loading ...
Loading ...
Loading ...