Loading ...
Loading ...
Loading ...
7
Electrical Connection
This appliance should be properly grounded for your safety. The power cord of this appliance is
equipped with a three-prong plug that mates with standard three-prong wall outlets to minimize the
possibility of electrical shock. Do not under any circumstances cut or remove the third (ground)
prong from the power cord supplied. For personal safety, this appliance must be properly grounded.
This appliance requires a standard 115/120 Volt AC ~ 60Hz three-prong grounded electrical outlet.
Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly
grounded. When a standard 2-prong wall outlet is encountered, it is your responsibility and obligation
to have it replaced with a properly grounded 3-prong wall outlet.
To prevent accidental injury, the cord should be secured behind the appliance and not left exposed
or dangling.
The appliance should always be plugged into its own individual electrical outlet which has a voltage
rating that matches the rating label on the appliance. This provides the best performance and also
prevents overloading house wiring circuits that could cause a fire hazard from overheating. Never
unplug the appliance by pulling on the power cord. Always grip the plug firmly and pull straight out
from the receptacle. Repair or replace immediately all power cords that have become frayed or
otherwise damaged. Do not use a cord that shows cracks or abrasion damage along its length or at
either end. When moving the appliance, be careful not to damage the power cord.
Extension Cord
Because of potential safety hazards under certain conditions, it is strongly recommended that you do
not use an extension cord with this appliance. However, if you must use an extension cord, it is
absolutely necessary that it be a UL/CUL-Listed, 3-wire grounding type appliance extension cord
having a grounding type plug and outlet and that the electrical rating of the cord be 115 volts and at
least 10 amperes.
Installing the Handles
NOTE: The appliance will be packed with two stainless-steel handles, one for the refrigerator and
one for the slide-out storage compartment. The handles are not specific to the refrigerator or
storage compartment, but they are installed differently. To install the handles, follow the
instructions below:
On the Refrigerator
1. Remove the door gasket on the left side of the door - you can see two designated holes for
handle installation. The gasket is easily displaced by hand; no tools are necessary.
2. Install the handle tightly, with the two screws and flat washers provided. (DO NOT over-tighten
as this will cause damage to the handle and stainless steel door frame).
3. Replace the door gasket to its original position.
On the Slide-out Storage Compartment
The set screws and lugs will be installed on the front of the slide-out storage compartment.
1. Set the handle over the lugs, and tighten the handle until it is secure using the provided Allen
key.
Loading ...
Loading ...
Loading ...