Loading ...
Loading ...
User Instructions Low Temperature Freezers Model UNI/LT
2
USER INSTRUCTIONS
Congratulations on your new low temperature
freezer. We trust that it will serve you for many years
to come. In order to gain optimum benefit from
your freezer, please read the following instructions
thoroughly and act accordingly. The low-tempera-
ture freezers are used for freezing and long-term
storing of food products, medical preparations (
vaccines, blood plasm, ect.) and other biological
products.
1. Environmental protection and disposal.
The packaging is designed to protect the
appliance and its components during
transportation, and it is made of recyclable
materials.
• Please return the packaging to an
official collection point for recycling.
• Old appliances contain reusable
materials and should not be disposed
of together with household refuse.
• Remove the spring-action hinges from
the appliance, in order to prevent
children from being entrapped in the
appliance.
• Ensure that no part of the refrigeration
tubing is damaged as the refrigerant
in the appliance risks escaping to the
environment.
• Information about refrigerant type
and amount will be found on the type
plate on the rear of the appliance
(Fig. 1).
2. Safety instructions.
• In order to prevent injuries and or
damage to the appliance, it should
be unpacked and set up by min. two
people.
• If upon unpacking the appliance is
found damaged, do not connect to
the mains, but contact the supplier.
• Interference with or repair to the
appliance should only be carried out
by authorized personnel, in order to
avoid any injuries. (contact the sup-
plier for further information).
• Never put naked flames or other igni-
tion sources inside the appliance.
• Never touch the freezers interior or
products in the freezer when the
freezer is operating. Use gloves or alike
in order to avoid injuries (frost-bite).
• Keep the key to the appliance away
from the appliance and out of the
reach of children.
3. Connection to the mains.
• For safety reasons the appliance must
be earthed. If you are in any doubt,
please contact an authorized electri
cian.
• The appliance should be left for 5
hours before it is connected to the
mains. If the appliance is connected
before that, there is a risk of damaging
the compressor.
• If for any reason the appliance is
disconnected from the mains, please
wait 10 minutes before re-connecting.
The electronic starting device needs
this time to cool down, before a safe
re-start can be made.
4. Before use.
• Before use, the interior of the appli-
ance should be cleaned with a mild
soap solution, and wiped off with a dry
clean cloth. Never use any kind of
solvent or other chemicals.
5. Setting up the freezer.
The freezer should not be placed where it
might be splashed with water, in extreme
high humidity or in direct sunlight. Any of
these factors may lead to a reduction in
performance and shorten the life span of
the components. The freezer should be
placed on a horizontal level, and should
not be placed close to a heating appliance
or heating tubes. Allow a minimum of 50mm
(2”) clearance on the side and the back.
The side with the ventilation grill should have
a clearance of at least 100 mm (4”) in order
to allow the heat from the compressor
motor to dissipate. Underneath the appli-
ance there should be a gap of 15 mm ap-
prox. (1⁄2”). On a soft surface, e.g. carpet,
it may be necessary to ensure the correct
distance by means of spacers.
GB
Loading ...
Loading ...
Loading ...