Loading ...
Loading ...
Loading ...
12
C
h
a
n
g
i
n
g t
h
e Wa
s
h P
r
o
g
r
a
m
You can change the wash program if the unit just started and only ran for a short time.
Otherwise, detergent may have been released and water drained. If this is the case,
the detergent dispenser must be refilled.
Press and hold the START/PAUSE button for three seconds or more and unit will be in
stand-by state.
The program can be changed at this point.
NOTE: If you open the door during a wash cycle, the unit will be paused.
After door is
closed, you need to press the START/PAUSE button to resume operation.
WARNING: opening the door during wash cycle may result in injury from hot water.
Note the following indications of the dishwasher:
·
All lights off = Stand by mode
· Display is on steady (not blinking) = Unit is paused
· Display is blinking = Operating
Fo
r
g
o
t t
o A
d
d a D
i
s
h
?
Dish can be added any time before detergent is released:
1. Press the START/PAUSE button
2. Open the door slightly to stop the cycle
3.
After the spray arm has stopped spinning, open the door fully
4.
Add the forgotten dishes
5. Close the door
6. Press the START/PAUSE button and unit will resume operation after 10 seconds
A
t t
h
e E
n
d o
f
t
h
e Wa
s
h C
ycl
e
When wash cycle has finished, the dishwasher will buzz for 8 seconds.
1.
Turn off the unit by pressing the POWER button.
2. Shut off water supply and open the door.
3. Leave the door ajar and wait approximately 15 minutes before unloading.
This will assist
in the drying process by allowing residual steam and heat to escape and the dishes to cool.
Dishes that are still hot are more susceptible to
breakage.
4. Unload the dishwasher. It is normal for the dishwasher to be wet inside.
Loading ...
Loading ...
Loading ...