Loading ...
Loading ...
Loading ...
6
ASSEMBLY & USE
ALWAYS use fresh cool water when in the water tank. ALWAYS make sure detachable
cord is attached to base. ALWAYS ensure the water level sensor float is secure in the
base.
1. WATER LEVEL SENSOR FLOAT (Page 4, Fig1 #5)- Remove float from plastic bag and place
into the base as shown in figure 1. IMPORTANT: water level sensor must be placed
securely in the base (see Troubleshooting).
2. WATER TANK (Page 4, Fig 2)- Place water tank onto the humidifier base ensuring the
Crane Logo lines up with the Power Button for proper water tank placement.
Fill water into the water fill opening. As shown WATER
in figure 2.
ALWAYS HOLD WATER TANK WITH TWO
HANDS WHEN FULL.
DO NOT fill water all the way to the rim.
DO NOT use hot water.
DO NOT add any medication, essential oils, (Fig. 1 (Fig. 2)
vapor pads or salt into the tank.
3. MIST CHANNEL COVER (page 4, Fig. 2 #10)-Secure the mist channel cover onto the
water tank. You will hear an audible click on top and bottom of the mist channel
cover to secure placement.
4. WATER TANK DISK (page 4, Fig. 3 #13)-Place the Water Tank Disk, with disk lip down,
securely onto water tank opening.
5. MIST NOZZLE (page 4, Fig. 3 #14) -Place the mist nozzle securely onto the water tank
disk. Direct the mist output by turning the mist nozzle to the direction you want the
mist to emit.
Note: Do not attempt to move the humidifier while full Water Tank is placed on the
Humidifier Base. Doing so may cause leakage of water and/or Humidifier Base to
overfill.
6. CONNECT AC ADAPTOR CORD into the Plug Port (page 4, Fig. 3 #15). Plug the power
cord into a wall socket and turn on the unit by using the Power Button. PRESS POWER
BUTTON (page 4, Fig. 1 #6) 1x for low, 2x for medium, 3x for high and 4x to power off.
Note: The Power Indicator Light will illuminate in green indicating that the unit is on.
IMPORTANT: After 20 seconds, the indicator light will turn off but product will continue to
run. This feature allows the humidifier to be on without a visible illuminating light.
SET THE CORRECT HUMIDITY OUTPUT: Adjust the mist output so the mist rises up to be
absorbed by the room air. If mist drops quickly, use the lower output setting so the mist is
rising up.
7. AUTOSHUT OFF When the humidifier runs out of water, the Power Indicator Light will
turn red and the mist output will stop. This is a safety feature to prevent the humidifier
from possibly overheating and damaging the Nebulizer. Turn the humidifier off and
unplug the unit before removing and refilling the water tank.
Loading ...
Loading ...
Loading ...