AOD24 Airo 2400W Outdoor Radiant Heater

Operation & Installation Manual - Page 4

For AOD24. Also, The document are for others Airo models: AOD18

PDF File Manual, 20 pages, Read Online | Download pdf file

AOD24 photo
Loading ...
Loading ...
Loading ...
Airo 4 Outdoor Radiant Heater OIM
IMPORTANT
READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE.
Always comply with the following precautions to avoid dangerous situations and to ensure
optimum performance.
Failure to carefully read and follow all instructions in this manual can result in equipment
malfunction, property damage, personal injury and/or death.
DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in
personal injury or death.
WARNINGS: Indicates a potentially hazardous situation which, if not a voided, could result
in personal injury or death.
CAUTIONS: Indicates a potentially hazardous situation which, if not avoided, could result
in minor or moderate injury or damage to the appliance. It may also be used to alert against
unsafe practices.
WARNING
REGULATORY / INSTALLATION
This appliance shall be installed in accordance with:
Manufacturer’s Installation Instructions.
Current AS/NZ 3000.
It is important that the following precautions are followed to minimise the risk of overheating, re,
electric shock and injury:
The appliance MUST BE installed at least 2.1m above the oor.
Handle the appliance with care, avoid vibrations and knocks. Unpack the appliance and check for
damage. DO NOT INSTALL A DAMAGED APPLIANCE. If the appliance is damaged or defective,
contact your supplier for advice, the appliance may ONLY be serviced by the manufacturer or the
manufacturer’s agent or similarly qualied person.
DO NOT install or use the appliance if the power cord is damaged. If it is damaged or requires
replacing, it must be replaced by the manufacturer or the manufacturer’s agent or similarly qualied
person.
Ensure that the voltage and frequency of the power supply correspond to the ratings on the data plate
of the appliance.
Models AOD18 and AOD24 are tted with an Australian exible 1m cord and 3 pin plug. A dedicated
240V 50Hz earthed 10 Amp power point must be used with this appliance.
DO NOT use power boards or double adaptors for this appliance.
This appliance MUST NOT be located immediately below or directly in front of a power point / electrical
connection. The power point / electrical connection is to be within 1m of the appliance, yet should be
located outside the physical footprint of the unit to prevent exposure to heat build-up behind the
appliance.
If the heater is to be mounted on an incline such as a vaulted ceiling, ensure the power point / electrical
connection is located at that lowest point of the appliance (see page 11 for details).
The appliance may be direct wired ONLY by a licensed electrical trades person in accordance with
local regulations.
The appliance should be connected to an electric circuit equipped with an automatic circuit breaker.
DO NOT connect the appliance to the mains power until it has been installed in its nal location and
adjusted to the position it will be used in.
The installation MUST BE equipped with an all-pole disconnection mechanism in accordance with
wiring rules.
SAFETY AND IMPORTANT INFORMATION
Loading ...
Loading ...
Loading ...