Loading ...
Loading ...
• Empty the drawer.
• Fully extend the drawer.
REMOVING DRAWERS
OPERATION
Slide carrier
Ball bearing slide - Pull slide carriers out on both sides
of unit to fully extended position. Hold the slide on the unit
while aligning it with the slide on drawer. Slightly insert one
side and repeat for the other side. Slowly push drawer to
its fully closed position to engage slide. Open drawer and
reclose to ensure proper operation.
INSTALLING DRAWERS
REMOVING AND INSTALLING SLIDES
• To remove the slide from the unit, rst remove the
drawer.
• After removing the drawer check to see if the unit has
rivets located on the front of the slide. To drill out rivets,
use a 5/32-in drill bit. The rivets will need to be replaced
with 5/32-in rivets.
• To reinstall the slide in the appropriate position in the
unit, align front and back lances with mounting holes in
the side of the unit. Pull towards the front of the unit and
downwards until rivet holes in slide line up with holes in
the unit. The rivets will need to be replaced with 5/32-in
rivets.
• For smooth operation, make sure the drawers are
matched with their original slides.
Drill out rivet
OPENING TOP CHEST DRAWERS
TO UNLOCK CHEST
• Unlock unit to open drawers and cover of chest.
TO LOCK CHEST
• Close all drawers and lock.
Note: Cover of chest can be closed if unit is locked.
• Push the lever on the right slide down, lift the lever on
the left side up. Pull out drawer to remove.
Right Release Lever
Left Release Lever
THIRD ANGLE PROJECTION
REV.
ECO#
DATE
BY
DETAILS / DESCRIPTION
Waterloo Industries, Inc.
SEDALIA, MISSOURI
PART NO.
SHEET
REVISION
DRAWING NO.
DRAWING IS DERIVED FROM SOLIDWORKS CAD MODEL AND IS PRODUCED IN ACCORDANCE WITH ASME Y14.100
AND RELATED DOCUMENTATION PRACTICES
THIS DRAWING AND THE INFORMATION IT CONTAINS IS THE PROPRIETARY PROPERTY OF WATERLOO
INDUSTRIES, INC. AND MAY NOT BE REPRODUCED WITHOUT WRITTEN PERMISSION FROM WATERLOO
INDUSTRIES, INC. PRODUCT ENGINEERING.
SCALE
SIZE
UNLESS OTHERWISE SPECIFIED
DIMENSIONS ARE IN INCHES
TOLERANCES:
ANGLE
1
2 PLACE
.03
3 PLACE
.015
OTHER TOLERANCES PER DWG 16856
INTERPRET DIMENSIONS AND
TOLERANCES PER ASME Y14.5M
TITLE
DRAWN BY
DATE:
MATERIAL
drawer
removal
-
GHOLCOMB
3/26/2015
1:16
SHEET 1 of 1
B
115821
UNIT ASSEMBLY
-
3
Loading ...
Loading ...
Loading ...